WRT8G3EWH Crosley Refrigerator - Instructions

Exactly as the video showed, except I had to take the evap coil cover off and use a hair dryer to thaw it out. It was still frosting up too much, so I ordered the thermostat as well. Both were really easy, once i saw the location of the defrost timer and the thermostat. Thanks for the great site, prices that put the big store to shame, and the good video too!

Removed shelf unscrewed screw on both supports replaced and secured.

place the bottom half of handle on the screw inthe door then placed the other end of handle over the door and screw in to place.

Cleaned the surfaces,installed the new handle...WaLa! Could not have been easier. Plus the new handle arrived in 2-3 days. AND was less than 1/2 the price of ordering through Sears Parts. I would use PartsSelect again in a heartbeat! Thank you for your great customer service.

We ordered a new bracket and it was installed and in in less than 10 minutes.

Popped the new retainer bar into place. Put the jars back where they belong. No worries! Couldn't have been less trouble.

it was easy my wife did it wen i went to the fridge it was already installed. thank you!!!!

Installed Metal hinge(old hinge was plastic) to take out sag of door.(painted the hinge color of refrigerator as hinge doesn't have plastic appearance cover )

My unit was not defrosting. Defrost heater was not functioning. Defrost heater tested good with a meter. Thermostat (cold) tested bad with a meter. Defrost timer was working properly. I replaced the thermostat but I had to buy red crimp connectors because the blue ones that came with the thermostat are designed for wire bigger than 18 AWG wire. The thermostat leads as well as the wire in my unit were 18 AWG. The crimp was not tight enough for my liking with the blue butt connectors. I also purchased smaller heat shrink tubing. After replacement, the defrost heater started working. I could see it glowing. Unfortunately immediately after getting the heater working the contacts in the defrost timer arced and stuck together thus preventing the timer from exiting defrost mode. The heater went off at this point indicating that the thermostat was now working. I then purchased and replaced the defrost timer and now the fridge is functioning properly. I noticed both replacement parts, even though I looked up my fridge model, were different part numbers than the originals. I'm guessing the new parts are improved? I also noticed the timer was an 8/30 rather than a 10/30 like the original. The fridge is working better than when it was new so evidently defrosting every 8 as opposed to every 10 hours is better for my unit.

Long story short:

Buy the correct crimp/butt connectors before beginning replacement of the thermostat and proactively replace the defrost timer since it is rather inexpensive.

The repair, if you want to call it that, was a complete no-brainer. The glass slipped right into the shelf. No tools were needed. I was afraid that the glass might break during shipment. However, it was packaged and secured several times over that it was in no danger of breaking during delivery. The part came sooner than I anticipated. I am extremely pleased with this order.

Just had to slide new part on to the back of glass shelf.

The shelf was out too far to be used on the bottom shelf. The top shelf, which was not as deep was then moved to the bottom and it worked fine. I am wondering if the shelf that was not as deep as the part I received is available. Thank you - maxine

Just block the door up so it doesn't fall off, remove the two screws, replace hinge, and replace screws. My wife could have done it. Metal replacement part is much better than the original plastic that warped from day one.

Unscrew the attached broken piece from the refrigerator (two screws). line up the new door handle with the existing screw holes and attach. Simple.

I took the shelf out and took part off and replaced the new one.