WRT21MP5AW7 Westinghouse Refrigerator - Instructions

Was Very Easy to Insert Glass .. Service was Excellent .I Definally would recommend and use this company again.

Just took out damaged part and poped in new retainer. Very easy!!!! Very reasonable part price Saved a lot of money A pleasure to do business with PartSelect

Problem not consistent. OK for 2-3 weeks, then freeze coils. Mark and observe the defrost timers manual rotating adjuster. Timer would stop mid cycle. One revolution equals 8 hours of compressor run time followed by 30 minutes of defrost. Replacing timer took 5 minutes.

remove shelf,unscrew rail, put in new rail,put in screw, return shelf

The new bar simply clicks on to the fridge door with no tools required.

1st. replaced the defrost thermostat pn 5303918214 did not fix it next replaced the defrost timmer pn 215846602 that did not fix it,next replaced the defrost heater pn 5303918247 still did not fix it,has the same problem as when I started I don't know what to do next guess will call for a service tech to come out,or get a new refridgerator. Looks like I wasted my money on these parts. Refridgerators are not as easy to fix as yall make them out to be. I have to say all the parts were easy to install and your instructions and videos were great, they just did not fix my refrigerator Thanks Tom

installed new slide support. No Problem. I would also like to compliment your service personnei on their prompt response. I believe I received the part within three days after ordering. Thank you

I followed the procedure online and found the thermostat was ok, it had continuity when cold, and the heater coil was also ok, it too had continuity, therefore the problem was a bad defrost timer. the refrigerator works great, thanks parts select!

The website said 60% of people with same refrigerator problem solved the problem with a new fan kit. I received the fan kit within 3 days of ordering. Was shipped from Fresno, CA to Long Beach, WA. The fan kit was to be installed behind rear panel in the freezer compartment. When I removed the old fan motor, I noticed the shaft turned harder than the new fan motor, suggesting a problem with the old fan motor. I plugged in the obvious fan motor power bundle with no problem. The instructions and diagram with the kit nearly steered me wrong. Instructions, diagram and splices with the kit instructed to cut the "extra" wire bundle and splice "similar" wires (should have said same color wires). Luckily, I ignored those instructions when I remembered the U-Tube video depicted the extra wire bundle was to be inserted into a factory penetration in the back panel, facing the freezer compartment. This power bundle is for adding an ice maker, which my refrigerator did not have. When reassembled and the refrigerator restarted, I could immediately feel forced air in the refrig, where there was no flow before fixing. I observed that all the refrig and freezer dials do is act like a valve to increase or decrease air flow to the compartments. The dials have no mechanical or electrical connections, just designed to divert air flow from across the cold 'evaporator' fins. I recommend other consumers to remember carefully what they see in the video and watch again if stumped during the job. The video was better than the instructions which may have been written in China or India. I am happy. Repair was a lot cheaper than a new refrigerator and I would not have bought another Frigidaire. Thanks to this website. r. andersen

I Ordered the shelf and placed it in the fridge. The process was so easy and convenient, and the replacement part came early and I found myself wishing everything was this easy...

I lifted out the old crisper pan cover and inserted the new one.

i read on line that it is easier to install the door gasket if you remove the door which also involves taking the freezer door off. start at the top and work your way down. easier with two people but one person can do it.not difficult, just press the gasket into the groove and the closing of the door will adjust it as is is needed.knowing this sequence will save you time.

Based on the diagnosis on this site I thought the 66% odds of the problem being the Defrost Timer looked pretty good, $30 including shipping versus a Sears tech phone estimate of $250-300. BINGO! Just follow the online installation instructions and don't forget to use the reset switch as described. Works like new! THANK YOU

The repair took exactly three minutes. I simply unscrewed the old piece of the handle off. I slid the bottom part of the new handle over the screw on the lower section, put the handle in placeover the top screw section and secured with new screws. So simple!

My part arrived 2 days after I ordered it!!! Great service!!! The old one popped right off and the new one popped right on. Easy fix no tools required!!!!!