All Installation Instructions for Crosley Refrigerator WRS26MF5AQZ

Icemaker quit making ice, clicking noise coming from lower rear of appliance

If this happens to you the first thing I would do is shut off the freezer and, using a hair dryer, melt the ice in the ice maker and heat up the water inlet to make sure it is not froze up. Turn the freezer back on and wait to see if that cures the problem. If not, order the new water inlet valve and follow the simple instructions in the video provided on the PartSelect website. I have never have a more pleasant experience with any parts/repair service than I did with PartSelect. After ordering that part it came within the time they stated and their help with the install was great. Also helpful were the other customers talking about their problems and solutions.Thanks to PartSelect I now have Ice and a happy wife. Happy wife--happy life.

Parts Used:

Refrigerator Water Inlet Valve

Paul from Cincinnati, OH
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Wrench (Adjustable)

Was this instruction helpful to you?

Thank you for voting!

replacment of two broken door bins

The bins don't easily snap into place, you have to twist them a little to make them fit into the support nubs. The trick is not to twist them too far or they'll split.Ours do, and now we store half-gallon OJ and milk back where the containers belong.

Parts Used:

Refrigerator Door Bin

Nat from North Hollywood, CA
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins

Was this instruction helpful to you?

Thank you for voting!

Quite making ice

The new inlet valve came with pisco connectors so had to cut the end of the tubes off. Before doing this I marked all the tubes to make sure they were replaced in the correct order. The pisco connectors are great to use and very quick. The total install time was about 20 to 30 minutes. While you have the back of the frig off make sure you vaccuum the fan and coils. It was making ice in less than 20 minutes.

Parts Used:

Refrigerator Water Inlet Valve

Charles C. from Denver, CO
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

Was this instruction helpful to you?

Thank you for voting!

Broken freezer door bin

Removes broken bin and installed the new one. No tools needed. Very easy.

Parts Used:

Refrigerator Door Bin

John P from Tucson, AZ
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

not cold enough

per the video..easy installation....unfortunately the temperature did not improve. We still have a refrigerator temp in the upper freezer.....and a "cooler" in the refrigerator section

Parts Used:

Run Capacitor

Gary from Hudson, FL
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Broken rail on meat draw

One screw taken off, part pops out, pop in new part, replace screw ! Done.

Parts Used:

Meat Drawer Rail - Right Side

Thomas from Flushing, NY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

ice maker was not making ice, no water flow into.

watched the youtube video from PartsSelect and was able to remove old water inlet valve easily and install new one with little effort. The hoses on my refrigerator were a bit different than shown in video, but I was able to modify them and it's working just fine now. Thank you PartsSelect !

Parts Used:

Refrigerator Water Inlet Valve

Mary from Mt Pleasant, PA
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Wrench (Adjustable)

Was this instruction helpful to you?

Thank you for voting!

When I opened the door, sometimes the light was not turned on.

With the help of a knife we took out the light switch unplugged it, plugged in the new one and it started working.

Parts Used:

Light Switch

Helen from Burnsville, MN
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

Bottom bin on refrigerator door was cracked, and fell off.

The new bin I ordered was delivered in one day.I was very impressed. The part just slid right on the door.No tools. Very easy. I'm very pleased.

Parts Used:

Refrigerator Door Bin

Camille M. from Branford, CT
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

Rails had cracked and drawer would not open without being held with a hand under it.

Took drawer out, took shelf out. Took old rails off shelf, put new rails on. Very Easy!

Parts Used:

Meat Drawer Rail - Right Side

Meat Pan Rail - Left Side - White

Patricia from Prairie Grove, AR
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

the drive blade for ice maker was rusted

first copy the explored view of all the parts ' ice maker tray ' then just take it apart slowly you need to get the blades back in the correct order and position thats what the exploded view is for in case you forget then you replace the blade and reassemble , it take a good hour .

Parts Used: