WRS23MW3AWA Westinghouse Refrigerator - Instructions

We watched your video online and just followed the instructions. It was super easy to follow and install the new parts. We would highly recommend your site to anyone. The parts came in the mail in 3 days. Thank you very much for saving us to call a repair person and saving us about $100.

Since the evaporator was all iced up, I decided to replace the least costliest item (defrost thermostat kit); did not resolve the problem. Once I replaced the freezer temperature control thermostat, the freezer temperature stabilized right at 0 degrees fahrenheit with dial on factory setting. Compressor no longer running constantly.

The part number was easy to find on the diagram. Delivery was as promised. Instructional film was very helpful and reassuring. Only problem was that the broken part left in the door was difficult to remove as it was distorted and would not slide out. Took considerable persuasion by screwdriver and pliers to remove remaining portion. New part went right in and reassembly was easy. Door works fine now.

Remove crisper and shelf. Use a small punch and hammer to gently push the tightening pin through to the wall of refrigerator, keep in mind you'll need to remove this piece with small needle nose pliers before installing new part. Set new part in place and lightly tap the pin in until flush. Install crisper and enjoy the rest of your day.

Remove cover, puch old pin into hole. Remove old support. Set new support in & drive pin in flush. Replace cover.

Instructions made the job very easy. Parts were an exact replacement. Thank you

remove and replace socket. adjust light switch so that it turns light off when door closes.

Undone the water line that comes up the back of the refrigerator and pulled the water tube out the back of the refrigerator and reinstalled the new one and reinstalled the water line. Done

Removed broken cover frame and drawer.: saved unbroken glass .With putty knife removed two front broken support clips.Inserted new support clips installed new ,cover frame installed drawer replaced glass cover and turned refer over to wife.

This was surprisingly easy to replace. Just a screwdriver (and a magnet to pick up the screw I kept dropping) and a little patience. The video was extremely helpful and walks you though step by step.

There is several videos on youtube which had this exact repair. 1) Unplug refridgerator. 2)Turn off water supply 3) Slide out the ice bin. 4) loosen the 2 screws with a 1/4 in nut driver. 5) lift out the ice maker. 6) unplug the icemaker from refridgerator. 6) transfer the leveling bracket from old ice maker to new ice maker. 7) reverse process and ice takes about 3 hours to start falling.

Exactly as the YouTube video described - really simple.

Cut the 2 wires going to thermostat and connecting the new. Then connect the thermostat to same place I unhookef the old one.

Watched the video....it was perfect. Just needed a Phillips screwdriver, needle-nose pliers and a 3/8 socket. The cam was shattered, so I had to pull it out the old, broken one with the needle-nose pliers. The whole thing took about 20 minutes. Really appreciate that video!

Just like the video. I had pulled all the parts of the old pin out of the frig months ago. I had tired to buy a replacement pin, but the local supply store could not get the correct part. I finally did a search and found your website. I was impressed with the pictures and the "how to" video.