WRS23MW3AQ9 Westinghouse Refrigerator - Instructions

Removed old fan motor and installed new one.Not much room for big hands back there.Flexible extensions valuable on this job.

removed the drip tray. removed three srcews that secure the frame around the ice and water dispenser. Disconnect the wire harness. Removed three more screws and disconnected another wire harness. Pulled the water tube from the assembly.Removed two screws remove old ice actuator and then installed the new ice actuator with two screws. reconnected a wire harness and then three screws to assemble the assembly to the frigerator. Then reinserted the water tube. replaced the frame with three screws and enjoyed and a cool drink with ice again.Easiest repair that I have ever done.

I was worried that the support was a permanent fixture in the refrigerator wall. But I pried it out and replaced it with the new part. Holes were exactly the same size so the new part easily replaced the old one.

took off cardboard removed two screws holding fan housing. Removed new fan and housing from box and mounted new fan to new housing (two screws). Installed new fan and housing. reinstalled cardboard and plunged in power cord. Perfect fit.

Purchase was easy. Delivery was quick. Install videos was accurate. Made it eady to as DI project. Safe place for purchase and support. Saved on cost of professional visit.

We watched your video online and just followed the instructions. It was super easy to follow and install the new parts. We would highly recommend your site to anyone. The parts came in the mail in 3 days. Thank you very much for saving us to call a repair person and saving us about $100.

Since the evaporator was all iced up, I decided to replace the least costliest item (defrost thermostat kit); did not resolve the problem. Once I replaced the freezer temperature control thermostat, the freezer temperature stabilized right at 0 degrees fahrenheit with dial on factory setting. Compressor no longer running constantly.

The part number was easy to find on the diagram. Delivery was as promised. Instructional film was very helpful and reassuring. Only problem was that the broken part left in the door was difficult to remove as it was distorted and would not slide out. Took considerable persuasion by screwdriver and pliers to remove remaining portion. New part went right in and reassembly was easy. Door works fine now.

Remove crisper and shelf. Use a small punch and hammer to gently push the tightening pin through to the wall of refrigerator, keep in mind you'll need to remove this piece with small needle nose pliers before installing new part. Set new part in place and lightly tap the pin in until flush. Install crisper and enjoy the rest of your day.

Remove cover, puch old pin into hole. Remove old support. Set new support in & drive pin in flush. Replace cover.

Instructions made the job very easy. Parts were an exact replacement. Thank you

remove and replace socket. adjust light switch so that it turns light off when door closes.

Undone the water line that comes up the back of the refrigerator and pulled the water tube out the back of the refrigerator and reinstalled the new one and reinstalled the water line. Done

Removed broken cover frame and drawer.: saved unbroken glass .With putty knife removed two front broken support clips.Inserted new support clips installed new ,cover frame installed drawer replaced glass cover and turned refer over to wife.

There is several videos on youtube which had this exact repair. 1) Unplug refridgerator. 2)Turn off water supply 3) Slide out the ice bin. 4) loosen the 2 screws with a 1/4 in nut driver. 5) lift out the ice maker. 6) unplug the icemaker from refridgerator. 6) transfer the leveling bracket from old ice maker to new ice maker. 7) reverse process and ice takes about 3 hours to start falling.