VBSR3100G0WW Hotpoint Washer - Instructions

Ok it was easier than typing this email. Remove selector knob. Use star*screwdriver to remove 4 screws at top. Pull the panel out toward you, lay down.Pry the lock tab up slightly with knife/flathead to clear the groove twist switch half turn counterclockwise and remove. Pull the vacuum hose off. Remove 2 wires. Now do it again in exact same order only in reverse. Youre done. Saved aprox. $280.00 and was a hero for the rest of the day.

I was frantically trying to find a cheap washer to replace the one that "broke". Fortunately, my son's roommate is a maintenance technician. He diagnosed the problem immediately. I googled the issue, found the part, ordered it and received delivery of the part in 3 days. It took all of 5 minutes to replace the part and reassemble the washer. Now on to the 15 loads of laundry that have been stacking up!

Took 30 seconds after I recieved the part from you guys. $8 repair. Sweet!

This job did not take much longer than 15 minutes if that.1st take the cord or twine and loop it under 2 paddles of the agitator.( there is a small groove under each of the paddles that has enough space to put the cord in) Pull up on the cord to remove the agitator. 2nd. Under the agitator is a bolt that secures the agitator coupling. Remove that bolt. Keep bolt(you may want to replace this bolt if rusted and worn. Mine was still ok so I reused it.) 3rd pull up on Agitator coupling to remove. Teeth were worn on Coupling, So discard. 4th Insert new coupling, replace bolt to secure coupling. finally slide agitator back over coupling till locks back in place. ....Done.

My 45 year old son did it in the shop, and it only took a short time before we were washing clothers again, and no water on the floor. The part came through the day after I ordered them. Thank you very much