RGB740BEH3WH Hotpoint Range - Instructions

First i tested where on the piping (i checked each pipe just in case, that is what caught the front right tube) it was coating the pipe in soap and letting gas flow to create a bubble by the leak. i then processed to order parts. in the processes of repair and check i noticed that the insulation for the vent was torn and decided to replace it and the hinge after i clumsily lost it. the installation was hampered by the fact that the nut by the burners was tight as if soldered in place. it is easier if you take out the lighter from the cage freeing it to be dealt with without having to do contortions. in order to work with out breaking the piping unscrew all screws from the all burners. and wreastal out the lighters from the cages so it does not bend the tubes too much(it is very easy to re"install" them just screw the cage back in and bang the lighter back in it wont break) Remember 3 things: 1)turn off gas and electric 2)keep track of every thing taken out and were it goes 3) check by the knobs as well (that is where ours were)

I removed the two nuts that secure the rear orifice tubes. This allowed me to lift the range top to access the broken tubes. Once lifted I removed the nuts that held the broken orifice tubes. I then connected the new orifice tubes. I removed the three(star)screws that fasten the orifice brackets under the range top. Doing this allowed me to connect the new tubes without having to maneuver them at all. I then lowered the top just enough to reattach the brackets. After securing the rear tubes I snapped the range top back into place. Just remember, if you use propane for cooking then you must remove the brass orifices from the old tubes and place them in the new ones. If you don't do this then your flame will not burn properly. Simply unscrew them from the old tubing and put them in the new tubing.

Husband actually did the repair, It went really well except he forgot to remove the heat shield from the old part to attach to the new bottom. (His mistake!)

I ordered the oven rack on a Tuesday and received it the very next day - was wowed at the service.

I have had my medal burners for 5 years and with young adults cooking I could not seem to get them cleaned. They had the part that I needed and now I have a whole new top stove. Thank you

I located the spark module at back of top panel and I switched the wires of one of the other burners to the burner that wasn't lighting. By doing that I found that part of the module wasn't operating properly.

My husband did the repair so it was very easy for me, as well as for him, he found the bad part from your parts diagram which was a great help, he changed it out in no time and so we were both very Happy. Thank you for your help. Nancy & David