KHMS1850SSS2 KitchenAid Microwave - Instructions

Removed old screws and pieces of plastic. Replaced new grill vent with old screws. Could not have been any easier

All it took was 2 screws and it was done - could not have been simpler.

Remove two screws, remove grill/bracket, replace grill/bracket, replace two screws and your done. Recycle if You Can.

Looked up the Whirlpool Co. and ordered the part. It was quite simple. Arrived in 2 days and I simply placed it in the microware. It was very very easy!

E. Robinson

Replacement of new vent grille took less than 5 minutes. I just wished Kitchen Aid made a product that lasted longer than 3 years. My part arrived very quickly, less than a week. Service was great and so was your price. I had no problem locating a replacement part. Kitchen Aid would not give me the parts number so I did not know if I was order the right part. But you photo really helped to narrow the correct part. Thanks

Opened door and put new plate in.

Placed order on Thursday evening and received Sat Am

Took this great-grandmother of 7 less than 3 minutes. Only needed a Phillips screwdriver. Easy as pie!

Unplug appliance. Remove total of 7 phillips screws from sides and front of bottom panel . Panel front drops down, remove one socket screw and socket. Now have access for lineman' s pliers to unscrew bulb base. Reinstall socket, replace bulb and 7 panel screws. Restore power.

Unplug the microwave. Then remove the six screws that hold the lower panel which has the light bulb cover and a couple of vent filters. The light bulb sockets are on a fixture that is connected by a quick connect electrical connector. Disconnect that and the whole panel is free to access the bulbs. My bulbs were very fragile and trying to twist them out resulted in the glass twisitng loose with the base still in the sockets. I needed to use a needle nose pliers to remove the bases and then I replaced the bulbs and put every thing back together

1. Remove two screws
2. Install new part
3. Replace two screws

Removed remaining plastic around 2 screws. I recommend a Magnetic Phillips Screwdriver, screw holes are a little Offset, and mount screws are small. I used Needle Nose Pliers to hold screw, to get it started. Really simple install.

Took out turntable and swapped out old one with a new bright and shiny
New one, ring that is. It was easy using the part from parts select
Thanks
Paul

Removed one screw lowered glass cover removed burned out bulb replaced with new one put glass back reinstalled screw. Dune 5 minutes back in business

Unscrewed glass panel, removed old bulb, cleaned glass panel and installed new bulb. Screwed panel back into place.

I was sent the wrong fuse by you. I had to procure a fuse in another manner. Very disappointing. The repair was simple. It just took longer because of the failure to send the correct fuse.