JVM1339BW02 General Electric Microwave - Instructions

Removed one screw, installed new lense in lense frame, rescrewed. Done.

pluged wires back on ,placed lamp holder and bulb back and replaced screws

Removed difuser (one screw), removed old bulb, screwed in new bulb, replaced difuser.

Tyring to get bulb out i ruined the light socket. Unscrewed the bottom cover of microware. Took out screw holding light socket, removed wires to socket with pliers, intsalled new socket. It was a piece of cake and the part was a perfect match.

Screwed in new bulb.

Replaced turntable coupler by removing screws from bottom of microwave and reaching through to turntable motor. The screws were a little difficult to get to because of the proximity of the microwave to our oven.

The handle worked great, the only thing was that it didn't come with the screw for the handle and I thought it would. The part description was very vague. So we have the bottom part of the handle super-glued and found a scrap screw that we could use for the top. At least it was better than no handle.

Thanks much,
Cheri Morena

Replaced - unscrewed top screw, removed door gasket with spatula, reveiling bottom screw to unscrew. Replaced handle,screw back on and replaced door gasket. Follow instruction on web site. Help greatly

Replaced the sockets, lens and bulbs. The first time the new bulb was touching the lens and the heat broke the lens and burnt out the bulb. The second time I adjusted the socket so that the bulb does not touch the lens.

Impressed by how quickly the parts arrived after the order was submitted. Two days.

Thank you.

took out several screws dropped down the panel under the microwave and unscrewed the bulb and put the new one in. It was a simple job.

Removed Cover Plate,
Removed back cover
Bulb disintegrated removed base with pliers
Screwed in new lamp
Replaced cover
Done

remove cover, unplug secondary door switch (top switch)
remove switch from holder, install new switch, plug in wires, replace cover, very easy. door switches are a common problem
with microwave ovens.

the top screw is plainly visible, the bottom screw is not and may give pause. If you remove the plastic ring, on the interior face of the door, it will give access to the bottom screw for the handle. While you have the handle off, remove the backing plate for the handle, on the front of the door by pulling outward, gently until it pops off. Then you can slide the front glass panel out and clean it. {CAUTION: do not spray any cleaner on the exposed glass with the mesh on it, it will be impossible to remove any liquid and will cause fogging when you replace the outer glass panel}. Replace clean glass panel, and handle backing plate, make sure it snaps in fully so the screw holes line up properly. Screw on new handle, replace plastic ring and you are back in business.

Used a phillips head screw driver and loosened the lens frame under the microwave. Removed the broken lens and replaced it with the lens ordered. Put the lens frame back in place and secured it with the phillips head screw.

2 screws off and 2 to put it back on. Not hard at all. Quick and easy.