Models > GWX8097SW119 > Instructions

GWX8097SW119 General Electric Washer - Instructions

All Instructions for the GWX8097SW119
1 - 3 of 3
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Handle plate would'nt turn
Pulled off the handle with the kneedle nose pliers replaced the plastic piece in that, then pulled off the plate that turns the machine on and just snapped the new one on. Only took seconds and saved alot of money. Considering just to have a repair man come to see what was wrong would have cost me $88.00.
Parts Used:
Timer Knob Clip
  • Karla from Boothbay Harbor, ME
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
wouldnt turn to wash cycle was turning manulie
its great and saved me lots of money enjoy my washer again
Parts Used:
Timer Knob Clip
  • Sharon from Mexico, MO
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Water Leaking Onto Floor At The Let Front Corner
Using the 1" putty, push in on the 2 clips holding the top of the washer. Lift top, exposing the top of tub. Remove old rubber seal from top edge of tub. To ease installation of new seal, stretch it over the edge of tub which tensions it, then start tucking the outer lip along the outside edge, tilting the seal towards the outside edge until the seal is completely in its groove all around. I had to hold down on the seal to keep it from rolling off while I lowered the top back down. When the lid is down, push hard to engage the 2 clips that lock it down.
Parts Used:
Tub Gasket
  • Robert from Wilbur, WA
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the GWX8097SW119
1 - 3 of 3
Back to Top