GWX8097SW119 General Electric Washer - Instructions

Popped the top by pushing in front clips with screwdrivers. Removed spin shield. Removed agitator and hub cover (all by hand). Used 12pt. socket to remove three bolts holding the tub. Pulled up tub (difficult b/c of weight and slippery residue). Loosened clamps w/ nutdriver and removed boot. Scrubbed clamps clean and reinstalled eve ... Read more rything.
Forgot to get clamps really snug, so it dripped a little. Did everything second time, but before replacing tub, did a leak check by running a load. Worked great. Good luck.

Pulled off the handle with the kneedle nose pliers replaced the plastic piece in that, then pulled off the plate that turns the machine on and just snapped the new one on. Only took seconds and saved alot of money. Considering just to have a repair man come to see what was wrong would have cost me $88.00.

its great and saved me lots of money enjoy my washer again

Using the 1" putty, push in on the 2 clips holding the top of the washer. Lift top, exposing the top of tub. Remove old rubber seal from top edge of tub. To ease installation of new seal, stretch it over the edge of tub which tensions it, then start tucking the outer lip along the outside edge, tilting the seal towards the outside e ... Read more dge until the seal is completely in its groove all around. I had to hold down on the seal to keep it from rolling off while I lowered the top back down. When the lid is down, push hard to engage the 2 clips that lock it down.