Models
>
GWX8097SW119
GWX8097SW119 General Electric Washer - Overview
Sections of the GWX8097SW119
[Viewing 2 of 2]
Keep searches simple, eg. "belt" or "pump".
Timer Knob Clip
PartSelect #: PS270835
Manufacturer #: WH1X2117
The timer knob clip on your washing machine connects the timer knob to the control panel. If your timer knob is damaged or will not stay in place, you may need to replace the clip. If the timer does n...
$11.00
In Stock
Compression Ring
PartSelect #: PS271609
Manufacturer #: WH2X650
This compression ring works in conjunction with the timer dial.
No Longer Available
Questions And Answers for GWX8097SW119
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the GWX8097SW119
[Viewing 3 of 3]Will Not Start
Fixed by
these parts
these parts
Show All
Leaking
Fixed by
these parts
these parts
Show All
Touchpad does not respond
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Handle plate would'nt turn
Pulled off the handle with the kneedle nose pliers replaced the plastic piece in that, then pulled off the plate that turns the machine on and just snapped the new one on. Only took seconds and saved alot of money. Considering just to have a repair man come to see what was wrong would have cost me $88.00.
Parts Used:
-
Karla from Boothbay Harbor, ME
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
2 of 4 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
wouldnt turn to wash cycle was turning manulie
-
Sharon from Mexico, MO
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Water Leaking Onto Floor At The Let Front Corner
Using the 1" putty, push in on the 2 clips holding the top of the washer. Lift top, exposing the top of tub. Remove old rubber seal from top edge of tub. To ease installation of new seal, stretch it over the edge of tub which tensions it, then start tucking the outer lip along the outside edge, tilting the seal towards the outside e
... Read more
dge until the seal is completely in its groove all around. I had to hold down on the seal to keep it from rolling off while I lowered the top back down. When the lid is down, push hard to engage the 2 clips that lock it down.
Read less
Parts Used:
-
Robert from Wilbur, WA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
Was this instruction helpful to you?
Thank you for voting!