GS2625GEKS Maytag Refrigerator - Instructions

Thought I needed a new filter. Did not solve the problem. I returned the filter to partselect as per instructions. Will order from partselect when I need parts.

Easy...

It took less that 30 seconds to pop out the old one and less that 30 seconds to install the new one.

Looked up issue on the internet and found that other folks had the same problem and said it was probably the compressor starter. This is actually two parts, a capacitor and a capacitor relay. Wasn't sure which was causing the problem so made sure I ordered the part number which inscluded both. One plugs into the other. Easy enough to just unplug the parts from the side of the compressor. Plugged in the new parts and compressor kicked on. Evrything working as normal. No one locally had parts in stock so overnighted from Partselect.

As per instructions to replace filter

I used a knife blade to slip under the edge of old switch to pray it out of the hole it was inserted into, switched the wires and replaced the new switch into the same hole. It took about five minutes!

The problem had occurred twice before and the metal auger could no longer be reliably forced back into alignment with its end cap. It was time for a replacement. I opted to replace the entire auger assembly including the crusher blade - a total of three individual parts in this assembly. With the Amana model and serial number in hand, I logged into PartSelect and found the ice maker part(s) in the fridge schematic diagram. I ordered the assembly which arrived early. It is easy to disassemble. Remove the ice drawer from the freezer, minus the ice, and place it upside down on a work surface. You only have to remove four screws; the two on the front bottom of the ice drawer and the two screws holding the little L-shaped brackets that receive those two bottom screws. Tip: To avoid any confusion during reassembly, just take a picture of each step of your disassembly. You can do it Noonan.

I snapped the cover plate to the filter open. Pulled the filter down and twisted counter clock wise to take filter out. I installed the new filter in by inserting the filter and tuning clock wise to secure the filter. I flushed the water for about two minutes and then allowed it to be put back into service.