GS2121NEDW Maytag Refrigerator - Instructions

unplug refrigerator, take backing off with nut driver. Pull old blade off and put new blade on. Put backing back on and plug in.

Simply stick a putty knife between the switch and refrig wall. Pop out old swith, remove both wires by pulling off switch by terminals. Throw switch out. Put wires on new switch and push into slot and all done. Nothing to it! Took me 5 minutes if th

Did all of work without removing door. Door is approximately 2 1/2" off floor, so shim door with a piece of two by four and wood shims to hold door level while removing bolts. Had mirror lying on floor underneath the hinge to see location of bolts. Removed 3 bolts that hold the metal bracket. After removing the bracket the pin slides out. Then remove another bolt from the door closer, this enables the old closer to be removed. Then replace new closer with one bolt. Slide hinge pin back in place making sure tab is toward refrigerator to line up with hole in metal bracket. Replace metal bracket with bolts. Tools used were 1/4" drive ratchet, 1/4" drive 3" extension and a 1/4" drive 5/16 " socket

I tried to remove the old light switch using a putty knife and a hammer. It was hard to compress the plastic tabs to pull it back through the hole, but all of a sudden, the lights came on. I guess banging on the switch freed-up the contacts. The new switch is now a spare part in case I need it.

After receiving the new part almost immediately,using two screw drivers, removed the broken switch from the plastic frame. Be careful not to scratch or otherwise tear the plastic...very pliable. Since the original switch was factory installed and the wires were packed in fiberglass insulation, the switch came out but the wires and clips were still in place and could not reach the new switch. It was necessary to pull them down with bent long nose pliers...used a lot of "pull" but the wires held up.Connected the switch, turned the power on and there was light! Reports from other users really took the uncertainty out of the task.

I watched the instructional video included with the shipping date e-mail(about 3 minutes long), and simply followed the instructions. It took about 2 days for the refrigirator section to return to normal cool temperature to the level set.