GFSR3110H0WW General Electric Washer - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Washer was overflowing both wash/rinse cycles
Ok it was easier than typing this email. Remove selector knob. Use star*screwdriver to remove 4 screws at top. Pull the panel out toward you, lay down.Pry the lock tab up slightly with knife/flathead to clear the groove twist switch half turn counterclockwise and remove. Pull the vacuum hose off. Remove 2 wires. Now do it again in exact same order only in reverse. Youre done. Saved aprox. $280.00 and was a hero for the rest of the day.
Parts Used:
-
Dennis from Charlotte, NC
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
knobs had cracks, not allowing the switches to turn
removed and replaced knob by just pulling old one off and pushing new one on.
Parts Used:
-
Norman from Colorado Springs, CO
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Washer wouldn't agitate
I was frantically trying to find a cheap washer to replace the one that "broke". Fortunately, my son's roommate is a maintenance technician. He diagnosed the problem immediately. I googled the issue, found the part, ordered it and received delivery of the part in 3 days. It took all of 5 minutes to replace the part and reassemble the washer. Now on to the 15 loads of laundry that have been stacking up!
Parts Used:
-
Jeri from Jourdanton, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver
Was this instruction helpful to you?
Thank you for voting!