All Installation Instructions for Whirlpool Refrigerator GARF19XXYK00

light would come on and off

Viewed the viedo - it showed what to do

Parts Used:

Refrigerator Door Switch

Dora from Rock Island, IL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

No Light

Took socket out and replace it with new one. Very easy. W saved alot of money doing it ourself.

Parts Used:

Light Socket Kit

Mary from Jefferson Township, PA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Frig not cooling.

After plugging in the new relay to no avail. I replaced the thermostat. That fixed the problem.

Parts Used:

Capacitor

Adam from Randolph, ME
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers

Was this instruction helpful to you?

Thank you for voting!

replace hinge bracket on fridge door

taped the door shut ,measured a block of wood and stuck it under the door for support.....unbolted bottom hinge,slipped on hinge bracket and reassembled.no muss no fuss.

Parts Used:

Hinge Bracket

Albert from Dunmore, PA
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Socket set

Was this instruction helpful to you?

Thank you for voting!

Switch didn't work

followed the video as instructed. Saved two repairman calls, one to find the problem, one to install. Net savings was about $130.00

Parts Used:

Refrigerator Door Switch

Don from Laramie, WY
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins

Was this instruction helpful to you?

Thank you for voting!

exchange of defective light rocker switch

1)pry out the old/defective light rocker switch with a screw driver (flat head) and pull out the cables 2)unplug two connectors at the end of light rocker switch 3) connect new light rocker into two connectors 4)push the wires inside and put back new light rocker switch

Parts Used:

Refrigerator Door Switch

Steve from River Edge, NJ
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Light in the refrigerator didn't work

I did exactly as the video showed. I popped out the old switch, disconnected the two terminals, connected the new switch and put it back. The light now works! The refrigerator is over 25 years old and the switch works! What a great website this is. Couldn't of done the job without Partselect's help.

Parts Used:

Refrigerator Door Switch

Anthony from Fairport, NY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Refer wasn't cold but freezer was working great

Removed the ice maker (3 screws) removed the back plate (2 screws) Remove the bracket holding the fan in (2 screws) Remove the rubber mounts on the old motor and the fan itself off the old motor. Then put it all back together in reverse order.

Parts Used:

Evaporator Fan Motor

Heather from Marysville, WA
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers

Was this instruction helpful to you?

Thank you for voting!

refrigerator section was not cooling

unplug, turn water off, remove ice maker & unplug,remove back panel remove old fan unit & unplug remove fan remove fan blades just pull off install new fan, put fan blades on new fan & install on bracket & re install plug in re install back panel. plug in ice maker re install ice maker . turn water back on plug refrigerator back in ( quite easy )

Parts Used:

Evaporator Fan Motor