FSG346RHS0 Frigidaire Dryer - Instructions

I watched the great easy to follow video from PartSelect. Absolutely nothing unclear. I was able to open the top and disconnect the front panel in less than 10 minutes! Removed the old felt drum glide, scraped off any stuck felt and loose glue. Then glued the new pad in place, using 3 small clamps, like clothes pins. Let it set for about 15 minutes then put it all back together! I did forget to reattach the ground wire, so I had to open the lid back up for that. About 50 minutes total. Also I took the opportunity of having the front panel off to give the inside a good vacuuming, not a ton of lint but enough to go ahead and clean it out! Thanks for the help!

Popped top off with flat head, took 2 screws out with phillips head, disconnected wiring, took front off, old piece removed, cleaned with razor blade, installed new glide, all done. I am sorry I waited so long to try this. So easy!

It was super easy! I followed the PartSelect video and everything went fine. Getting the drum out of the machine was a bit tricky but once it was out, the rear bearing kit went in without any problems.

Unplug dryer from outlet.I removed the screws from the back panel behind the controls. The switch has 2 wires that slip on the switch terminals. I slipped them off, gently lifted the catch located on the switch and rotated switch which is just held in place by two slots. It fell off in my hand when slots were aligned. Copied part number, ordered part, replaced on dryer. Works like a charm. Part arrived in 2 days. Thanks.

I watched the videos on this excellent website first. Then the repair was a breeze.

I followed the instruction video and easily removed the drum. Mine is a gas unit, so the best access to loosen the pulley and belt is by removing a small hatch on the back of the dryer. Removing the ball shaft was initially difficult, since the screws had been stripped by the previous repair person. To solve this, I used a vise-grips to turn the protruding shafts of the screws at the drum rear, and unscrewed them partially out from behind. Once loosened, I used a screwdriver to easily finish them. The old bearing was actually gouged, and there was no lubrication at all in the retainer cup. The job took 2+ hours, since I also replaced the upper felt glider and spent 30+ minutes vacuuming the dryer out.

installed the back bearing with the ball bearing and dropped in the rear drum bearing and tried to install the drum to the rear drum bearing, but we could not find the screw holes to attach the drum, we tried and tried and finally I came up with the idea to take the drum out and screw the drum bearing while we had it ouside and that worked out beautifu lyl and all we had to do was reinstall the drum and all we had to do was lift it up just a little and drop it into the retainer rear retainer' and then all we had to do was install the tension roller which we had a little trouble but we finally figured it out and now it works just fine, it would a lot if there was a diasgram included on how to re-install the tensioner

Removed the panel between the dryer and washer. The gas valve was right in front. The wires were in a plug and easy to remove from old part. The solinoid held in place by a clamp with two screws.

it was so easy using the video that you emailed me. I want to rebuild my whole drier now .