EF36IWFSSS0 Dacor Refrigerator - Instructions

20 seconds. Easy Easy.

I'm uoset that I sat and looked at the broken piece for a month wondering"what the heck is this going to cost me" The more you spend on the appliance the more they break. The repair was too easy. Remove the 2 drawers, remove the bottom draw and there are 3 nuts you need to back off. The whole piece comes off really easy. I left the drawer glide on and took it off after the whole piece was out. Attach the glide to new piece put it in place and screw it back together. Now gow wash the drawers and glass that you have been putting off and reinstall them. Start to finish 10 minutes,.

I did remove the run capacitor of the starthing kit of compressor and another one new. It work fine.

Opened up the compartment where the old filter was located, twisted it to take it out (be careful not to spill water in the filter!), and installed the new one. Even a 64 year old woman had no trouble!

Removed the left hing side and replaced it

replaced electric control board, defrost for six hours. next day (24 hours) same problem, dusterhoff2928@charter.net

After years of using a flash light to check the contents of my refrigerator, I decided to try to fix the problem myself. Replacing the light switch was very easy. The directions were straight forward and I'm sorry I waited so long to tackle the problem.

Took out 2nd new filter $43.00 each that clogged in less than 2 weeks each and installed in 2 mins. this bypass and ice and waterr work perfect.Thank you, thank you for your exceptional service ordered part and it came next day without extra charge,great service.

Just replaced a water/ice filter..

Very easy to replace the old broken piece with the new one. Simple

Simple! Pop the case open. Counterclockwise to remove old filter. Wipe out excess water. Unwrap new filter; remove tab. Place in filter holder; turn clockwise. Close case. Run water to remove air. Couldn't have been easier!

Was a snap. Took out the draws. Removed glass plate. Unscrewed endcap using socket set. Removed rail. Screwed rail to new endcap. Screwed in encap. Replaced all draws and plates. Didn't take more than ten minutes.

No instructions with part. Found a picture on line and changed the arm, but it didn't fix the problem. Fairly easy after figured out what needed to be done to get to the part.

piece of cake to repair - great instructions!!

We had an Appliance Repair service come to fix, and they replaced the ice maker and the water valve, but ice maker was still not performing properly. We use RO water to fill the ice maker and because the water was also going through the charcoal cartridge, there wasn't enough water pressure to completely fill the tray. Plus charcoal filter was probably clogged. The original Blue Bypass Cap was nowhere to be found and I even called Kitchenaid to get one. They were of no help. But found your site, and found the part I needed. And best of all, ice maker is not jamming and is now making real ice cubes, not hollow, thin ones. And the water dispenser is now working too, so am very happy that such a small thing, fixed the big problem. Who knows, a clogged charcoal filter may have been the whole problem from the start.