DW760S Jenn-Air Dishwasher - Instructions

I took the inner door panel off, disassembled the soap cup door mechanism, and installed the new latch and seal. By replacing the seal around the latch, the leak problem has been solved. Thank you!

Pulled the old gasket. Cleaned gasket channel very well. Centered middle of new gasket with the door latch. Then worked gasket in both directions to both ends. Closed the door and left with door tight for several hours to allow it to seat with the new gasket. When use was resumed the leak, at least to this point, has stopped.

remove panel on front to acess float @ float switch.Remove phillips screw to float switch,remove palnut from float shaft with 5/16 nutdriver.Remove float from inside washer.Reinstall new parts reverse order.

Real easy. I checked out the instruction video. It was great no problem making the repair....Thanks

Unscrew round keeper on top of spray arm -CCW. Lift off spray arm. Remove the six Torx head screws aroun pump housing. Lift off pump housing. Unplug unit and obtain a small piece of 2 x 4 wood to block up the motor underneath. Push the white plastic lever near the left side of motor towards the back to loosen the entire unit. Place the wood block uner the motor and you will see the seal is accessable inside the dishwasher. Remove the seal and very carefully clean the area that accepts the new seal. Remove the block and pull back on the white plastic lever. Done!

I bought the replacement rack which fits, accommodates the cutlery container but does not come with clips and hits the spray arm. Too bad they can't make an arch over the arm. Also, why did they stop making the clips for the rack pieces? We are trying ties for now. But have to be carful to not hit the spray arm.

out with the old in with the new

Replaced the door latch.

Watched video you have on the site.... also read the first person's description - both very helpful...since I am 75 y.o.and a woman got my chair to sit and did exactly step by step and actually did it! So happy I wouldnt have to buy a new dishwasher YET - Emailed my friends and said if and when they need wheel replaced I can do for them!!! Thanks for all the help on site.

Replaced the inner door foam insulation strip and door gasket.I believe the "secret" is not to push the door gasket in all the way. Let the door find its own seat. Problem fixed.

customer service was great depart was easy to install and worked like a charm

This was as simple a repair as you will ever get, at least on a 16 year old Maytag like we have. Literally just take the old gasket out and put the new one in -- just make sure to look at the old gasket to ensure you are inserting the proper end of the new one into the channel, I almost put it in wrong, but then again I'm brain damaged where home repairs are concerned. The door is more difficult to close after I put the gasket in, so I may have to adjust the door closing mechanism just a tad.

Great instructions, great service. But I have not yet made the repair.

plastic form inside dishwasher does not press into foam insulation strip hard enough to stop water from leaking. It is still leaking

It was super simple, the web site was excellent in helping me purchase the proper parts, even when a slight error was made in my order(2 parts bags were ship that were empty)I contacted the service department an they immediately sent out the parts at no charge. I replaced the dishwasher cover in about 10 minutes. Probably saved a couple hundred dollar from a service call. Thank you.