DSD26DHWABG General Electric Refrigerator - Instructions

It couldn't be easier. Just pry out the old broken switch with a flat blade screwdriver. start at the bottom in case you scratch the door by accident. When the bottom is out - pull the switch out slowly and disconnect the two wires that are attached to the top, taking care to remember which color lead is connected to which wire. Then, take the new switch and connect the proper wires to their respective terminals and push the switch into the slot. Done!

took 1 screw out and removed ice maker and slid new one in and replace screw and connected power cord

First determined my modle did not require any of the wire mods descibed on the instructions. Removed power and three cover plate screws. Removed board connectors. Calapsed board anchors and removed board. Removed existing ground wire from board. Installed ground wire on new board and installed board on four mounts. installed connectors and replaced cover and screws. I did wear playtex gloves so as not to cause a static short and wipe out the new board. Took off the bottom panel and cleaned condensor fan cage while I had the fridge out. Secured, plugged in fridge, works real fine, lasts a long time.

Changed the broken parts