All Installation Instructions for Hotpoint Refrigerator CTE21GATMRWH

Broken meat drawer side rail

The hardest part was figuring out the part needed from so many little pictures. The actual repair, a piece of cake!

Parts Used:

Drawer Slide Rail - Right Side

Ann from Hanover, NH
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Office refrig. A rat chewed thru.drain part.

Sears told me the part was no longer available. I came to your web site and then called your customer service. A very nice customer service lady helped me find the part. Very simple to pull the old one off and reinstall the new one with a rat trap behind the unit. Just in case it came back. Could have been a client but probably was a rat. Thanks for the great service.

Parts Used:

DRAIN GROMET

Allan from Tampa, FL
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

The Front bar was torn from the Slides and drawers were broken.

Placed slide assembly on table and followed the steps shown on your video.Thanks

Parts Used:

Lower Crisper Drawer

Center Cover Slide

Drawer Slide Gasket

Howard from Silver Spring, MD
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Refridgerator Door Gasket Needs Replacing

I watched some videos online trying to find one that pertained to my door gasket and found a couple. After that it was a snap. The old gasket came off easy and the new one went back on easy. I did however submerse it in hot water first to kind of even things out.

Parts Used:

Fresh Food Door Gasket

Ed from Mason, TX
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins

Was this instruction helpful to you?

Thank you for voting!

left side rail broke in half middle support broke at front end

As instructed actually my wife ordered the parts and
Installed herself. Positive experience.

Parts Used:

Vegetable Drawer Slide Rail - Left Side

Center Cover Slide

JOE from INDIAN ROCKS BEACH, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

Was this instruction helpful to you?

Thank you for voting!

failed light switch

I started removing the switch by prying on the right side with a screwdriver, when it emerged enough I used pliers to finish removing it. I then unpluged rhe wires from the bad switch and pluged them on the new switch and "poped" it into the hole.

Parts Used:

Light Switch

Jules from Crowley, LA
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers

Was this instruction helpful to you?

Thank you for voting!

no light in freezer

Connected the 2 wires and pushed in the switch until it clicked.

Parts Used:

Light Switch

christopher from collegeville, PA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

part did not fit.

was able to grind the edge to map it fit

Parts Used:

Meat Pan Slide - Left Side

James U from Pawleys Island, SC
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

Was this instruction helpful to you?

Thank you for voting!

refig light did not work

per your instructions

Parts Used:

Light Switch

paul from east hanover, NJ
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Noisy fan

Emptied freezes, turned off power, took floor of freezer out [4 screws ], took two screws out of fan mounts and replaces fan. Reassembled by reverse process. Simple

Parts Used:

Evaporator Fan Blade Kit

Robert L. from Eldred, PA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

switch wouldn't come out anymore and turn light on

Gently pry out switch in door jam with screwdriver and pull both connectors off and put connectors on new switch then push switch back into the hole. Looked it up on the internet and video showed how to and also had link to new part, ordered and less than a week later the fridge is bright again. I have an older freezer also and it seems that they all use the same switches. Very Very easy

Parts Used:

Light Switch

Cynthia from Seatac, WA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

slide rail broke (after ten years of use) when I yanked it too hard while cleaning the fridge,.

Ordered a new one and watched a YouTube video on how to do it. Really didn't need it, but it was a nice touch by Part Select because it made the repair go faster than it would had I not seen the video. All it took was one screwdriver, which is what the video said, and a little aligning of the side rail with the from piece. Screwed it together (2 screws) and that was it .

Parts Used:

Vegetable Drawer Slide Rail - Right Side

Ronald from Marlborough, MA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Refrigerator and Freezer seals not working

I followed the instructions and had no trouble. The refrigerator now cycles on and off as it should. The iside temp. is much colder and I know there will be a good savings on electricty.

Parts Used:

Fresh Food Door Gasket