CSK27DHXAAA Hotpoint Refrigerator - Instructions

The part came within 3 days. But it was only one cam. Part was described assembly so i thought it had both cams. I ordered the upper cam which attached to the door bottom. When I matched the new to the old --they were different. They looked the same until you put them side by side. Being the mechanic I am, I cut the rivet holding the assembly cam and pop riveted it to the old assembly. It was not difficult but annoying as I had the correct model (I have the original use and care guide book). I must commend PartSelect for their promptness.

Ordered new Ice Maker from you and fixed the problem completely.

The trim piece covering the opening of the dispenser is the first and most difficult part of the disassembly. Take care when removing this piece that it does not break.

just i took off the actuator and replace with the new one in 8 minutes.It was so easy.

Followed the online video exactly and it was easily done. Couldn't have been better. The problem is solved.

the pad is a slip in I just used grease to allow for the friction and had it in with in a minute

I first replaced the ice bucket which allowed the auger to turn but did not fix the problem. I then ordered a new solenoid and plunger and after installing them it now makes ice cubes. Problem solved.

Removed frame, unscrewed the electrical panel, and popped the flapper off. Installed new flapper. Replaced the electrical panel and re-installed the frame.

Removed the ice maker control panel and accessed the flapper door, easy switch out for new door and seal. The 2 year old warped seal didn't close and so ice crystals formed in the freezer - new unwarped part and Ta-Da no more problems :)

I had to defrost large chunks of ice from the rear of the freezer compartment and tried reactivating the ice maker several times before deciding to order the replacement fill tube grommet and clamp. This was very stressful and complicated to accomplish while trying to avoid food spoilage, and consumed a lot of time. It involved removing the ice maker and various panels, plus disconnection of 2 electrical plugs, then using a hair dryer to melt ice build up. The installation of the new parts was quick and simple once they arrived in the mail, and this appears to have solved the leak problem. The fill tube slides easily into the grommet and the clamp, tightened with a screw driver, secures the water feed line on the other end. Fill tube must be carefully threaded through rear panels and into the ice maker receptacle and the grommet needs to be pushed hard and wiggled in order to seat properly in the rear surface of the refrigerator.

Popped off the front frame and front of mother board. unscrewed the assembly to be able to lift up to get to flapper. Lifted it up out of the the way ( wires are attached so it may take one other person to hold it up out of the way). Pop out the old flapper and replace with new one. Easy !

Repair went exactly like the video. With this video it was easy to make the repair. There were no surprises or problems and I felt confident in the videos instructions. It was like pushing the easy button.