CSC27HRBAD Hotpoint Refrigerator - Instructions

Gently pry out switch in door jam with screwdriver and pull both connectors off and put connectors on new switch then push switch back into the hole. Looked it up on the internet and video showed how to and also had link to new part, ordered and less than a week later the fridge is bright again. I have an older freezer also and it seems that they all use the same switches. Very Very easy

Super easy, had my 15 year old do it (with my supervision).
Followed very clear Instructions that come with the replacement...
But, he could not get to the plug location until he removed 4 screws holding the motor assembly that spins the ice in the drawer and moved it out of the way...
Followed the rest of the instructions...
Works like a charm.

I removed the valve from the fridge with a nut driver, this allowed me to disconnect the two lines and the water main inlet. Re attach the main line and cut off ends of both plastic lines with a razor knife and re insert the two lines. Last was to connect the main water inlet and tighten . The last thing was to turn on the water and check for leaks and we had none so put the fridge back in its proper place and job done. Thank you for your help Michael

Ordered Auger and Ice Bucket Assembly All I had to do was install 4 screws. Worked great. Thanks.Joe

Installing the actual ice maker was quite easy. What takes most of the time is preparing the freezer for the install. Need to remove all shelving, (and the door) to gain access to the unit. The ice maker is simple to install once access is achieved. Putting everything back together takes some time.

I'm a real novice at appliance repair but learned a lot from this effort. After doing enough online research and watching videos, I diagnosed the problem with my 20 year old ice maker. It was working, just not getting water. So I ordered a new water valve, much cheaper than the part Sears recommended. I easily hooked up the new valve but the old copper water supply line was leaking so I ordered a $7 pex line from Home Depot. Hooked it all back up and now I'm in business, and saved some money too!

Piece of cake and now I get loads of ice.

replaced the switch that activated the system

Followed instructions that came with time, also viewed the video of website.

Repair was really easy, bought the part because of partselect video. Saved myself a lot of money vs calling a repairman.

Followed the instructions. Smooth as silk. This part is better than the original. There appears to be a sensor that beeps when the ice reservoir is full.

turned water off removed old water valve moved wires to new one moved water supply and discharges to new one reinstalled new valve

I simply ordered a new Ice bucket, removed about 6 Phillips head screws, removed the old bucket from the Ice door and replaced with a new bucket. SIMPLE !!!!!

I used the how to video from the site and had the part replaced in about the same time the video did it, even with being distracted with a phone call.

did it just as the video showed. it was a little different, but absolutely nothing that we as ametures could not figure out! very easy and I think it was just the part we needed! biggest thing was unloading refrigerator!