BBBD2432KW0 Frigidaire Dishwasher - Instructions

Took the screws out, Took the 4 wires off. Replaced the wires on new part. Put the screws back in. Takes a star screw-driver to get the latch screws out and in.

Snapped new part in place in about ten seconds.

Order a new one from PartSelect. It got here real quick. Also there is a video that shows how to replace it. It only took about 5 minutes

Very simple, pop old one out and pop new one on.

Snapped the arm right on and no more leaks.

Pulled out bottom gasket, inserted new gasket. Max about 5 min. Pulled out tub gasket,cut new gasket to match old gasket and pressed into tub.Max about 10 min. Spent more time putting kick plate back on.

The bottom gasket slid straight out, after which I cleaned the slot a bit, and the new gasket slid in perfectly. The tub gasket pulled out by hand, and again, after wiping down the groove, I easily fit the new gasket around the tub and trimmed a few inches from one end. There is no longer a problem with leaks, and I think the door closes a bit more securely as well.

had to pull out dishwasher,disconnect electric and plumbing flip dishwasher on its side.remove screws holding pump in replace O rings and pump reinstall all plumbing and electric. slide dishwasher back in place..worked great,not too hard.

The Nut was still attached to the dishwasher. I went on Partselect and found the assembly that I needed. I ordered the part and when it arrived 3 days later (weekend)I screwed the new sprayarm into the dishwasher. Total repair $26.00 less than the price of a repairman's labor costs. Partselect has very reasonable prices, Thank You.

If you order this, be SURE to specify with spray arm - upper or lower. I literally unscrewed the old part and screwed the new part in. It was that easy!

Unscrewed the old one and put the new one on very easy took less than ten min, the part was perfect fit

This is "one piece part". If you have more than one part, then you need to replace it. Really easy, order the part, uncrew the old one, screw on the new one.

The hose goes from the water inlet solinoid to the side of the dishwasher.Remove the kick plate from the bottom front of the dishwasher. Disconnect the water supply to the inlet of the solinoid valve (copper tubing on mine). Remove the screws under the counter top which hold the dishwasher in place. slide the dishwasher out from under the cabinet only as far as needed to expose the hose(about 1 foot). The hose is behind the insulation. Remove the hose clamps from both ends of the hose(solinoid outlet and side of dishwasher)Remove hose carefully because this is all plastic. Install replacement hose and clamps. The new hose is several inches too short and will not fit into the upper hose guide, just bend it underneath. Be sure to put hose in lower keeper on side of dishwasher. Attach clamps, tape insulation back in place, slide dishwasher back under counter and install screws under counter. Attach copper tubing to water inlet solinoid valve. Run dishwasher and check for leaks. Replace kick plate. Note: I had enough loose electrical wire to slide my dishwasher out. If you don't have enough wire to slide out the dishwasher you should call a repair man.

Ordered a new one.