AYE2250AYA Admiral Dryer - Instructions

Watched the repair video on part-select. Pulled the top of the dryer up after removing the lint trap screws.removed screws at top, inside both sides and then lifted front off. Slipped belt over drum and ran through tensioner and around motor shaft. Put dryer back together in reverse order. Simple.

Dryer shut off during operation and had a burning smell. Dryer would not turn on after that. The PartSelect website helped me diagnose the problem as the thermal fuse blowing out. I bought a high limit kit from their website, and their step-by-step repair video (http://www.youtube.com/watch?feature=player_embedded&v=tzEi3HpzLJA) made the repair simple. For about $25 I was able to repair a dryer that would have cost me hundreds of dollars to replace. Thank you, PartSelect!

First I check the conduction with a voltmeter of thermal fuse, high limit thermostate and the swith door. The thermal fuse was broked, I order the high limit kit for replace the fuse and the high limit thermostate too. I open the dryer using putty knift on the front. With screw driver uninstall the high limit thermostate and the heat wire to access at thermal fuse. Note that thermal fuse have white wires and the high limit thermostate have red wires. I install all back and my dryer work again. I recommend before close the dryer, vaquium all inside dryer. It was very easy. To me help very much the video that you show.

Exactly as described by the video.

I used a putty knife to push in clips to lift the top of the dryer off to gain access to the thermal fuse and the high limit device. The thermal fuse was close to the top and easy to do. The high limit part was a little further down the back side of the dryer and a little harder to get to, but watching the video online helped a lot. The most important part was fixing the root cause of the dryer. Lint. I empty the lint tray every single time I dry a load, however, after removing the front panel, I found 12 years of lint packed into the channel. (You may want to do this BEFORE your dryer goes out.) After removing the lint and replacing the parts the dryer works like new again, and it only took about 30 minutes! I am a 57 year old woman so if I can do this anyone can. The best part was that I ordered my part on a Tuesday morning and it was delivered the very next day! Great service!

Replaced it.

Watched the video and performed as instructed- Could not have been easier- Great site with Great information

I came home from work to notice the dryer singing a different tune than usual. I opened the door and noticed that the tub wasnt turning. I popped the top of the dryer up to find a disentigrated belt. Fired up the computer and in a few minutes had ordered the $8 ($15 including shipping) replacement belt. 3 Days later took the shopvac and cleaned up the lint and broken belt pieces. Installed the new belt and was back in business with my 8 year old dryer. ** The only complaint comes from my wife who got her hopes up for a new front load washer and dryer** thanks partselect for saving my wallet in more than one way!