Lint Filter

I pulled out the broken lint filter and put the new one back in, real easy. I am so happy with the prompt delivery I got from PartsSelect.com. I ordered on a Monday and and it was delivered on a Wednesday

Lift the top. Remove (2) screws holding the front of the dryer in place. Lift the front off the 2 retaining clips on the bottom of the dryer. The hardest part of the install was removing and replacing the igniter. A couple of helping hands from the girlfriend to hold the parts in place while I replaced the two screws was very helpfull. Installing the multi rib belt was also very easy with the help of a second pair of arms to reach under the drum to thread the belt onto the tensioner. The lint filter, of coarse was just a matter of throwing the old cracked one away and replacing w/ the new.

First went and got a beer.
Looked at the dryer.
Drank my beer.
Went and got one more, due to long job.
Looked at dryer again.
Opened the door.
Had to get one more beer.
Removed filter.
Got one more cold one.
Put new filter in.
Got one more beer.
Closed door.
Finished!

Not sure, my husband did the repair but said it wa real easy and if he can do it anyone can, lol

Parts Select made it extremely easy to order parts from their site. Parts came in a timely manner and very reasonable priced. Thanks to Parts Select! Door Seal just needed to be removed and replaced by pushing into little slot openings.

It was easy - I had my 12yr old daughter do it. The old door seal was completely removed, then you placed the new seal in the apropriate knoches that are on the door of the dryer. The lint filter just had to be placed in the vent. - Done.

I slid in the new one

First I removed the two screws that hold the element in place. I then pulled the element completely out and disconnected the two wires.

From there it was just a matter of installing the new part.

Anybody could do it

Changing the parts was easy.

I first confirmed that the ingitor was working (because I could see it glow with the lights off at the bottom of dryer). I read within Parts Select that intermittent heating was likely the coils and that I could test their resistance to confirm that this was the problem. I removed the coils (very easy) and thenI checked their resistance with a tester. The resistance on one of them was reading 600 ohms instead of the required 1300 ohms. So I replaced them both and presto it works fine. I also took the opportunity to thoroughly clean out the lint (accessible with the front panel removed) and I replaced the lint filter which was ripped and the gasket around the door which was missing a piece. All very easy to do and parts select made it a cinch. For safety I made sure that the gas and electric were off before I did any of this work. oh, I also levelled the foot which made my wife happy.