AFD2535FES Refrigerator - Instructions

Took of slider for drawer and put them on new part. Unscrewed three screws, took of old part and put on new part and screwed on. If I can do it anyone can.

As per directions

Remove drawers. Remove 1/4 screws. Remove end cap. The linkage for temp control is very fragile so be very careful. Not a very dificult task at all.

Had I not confused the old ice maker with the new one and tried to reinstall the old ice again I would have been done in less than 15 minutes. The instructions were clear and helpful, the parts all fit and it went right in. It worked within a few minutes and has been perfect since. Thanks

Removed the single screw holding the ice maker in Place and unlugged wire ,then removed cover off of the end of ice maker and the three screws holding the actuator onto ice maker and installed new one. Reinstall ice maker......works great

R&R unit in 5 minutes, very easy...

I am not very handy at all. The you tube video showed me exactly what to do. I removed the ice maker from the refrigerator by loosing two nuts and removed one screw. Replaced the motor by removing three screws.

Remove tray that held ice then took off cover to the moter.removed three sewes that moter came off .then put on new one

I removed the ice maker, saw the problem, took the ice maker apart and ordered a new mold. I reassembled it with the new mold and it now makes ice but the control arm remains up after each ice dump. I plan to take the ice maker back out when we leave (we are snow birds in Florida) and see if the arm is properly placed.

My husband took the plastic cover off and took out old bulb and screwed in the new one. Then put the cover back on.

Followed the video and in less than thirty minutes the new icemaker was installed and in under an hour we had ice!

Replaced the ice making assembly and all works fine now. PS2121513 Ice Maker Assembly

Removed pantry and glass shelves. Remove three small screws. Pop out end cap and remove drawer rail(two phillips screws). Reinstall on new end cap and place back in refer with three screws. Reinstall glass shelves and pantry. Job complete!!!

Took all the shelves and drawers off above part to be replaced and cleaned them. Removed old part and replaced with new.May I add new part fit perfectly!. No major problems encountered. Tip: remember where all parts were removed from!

I watched the video that was offered after I placed the order which was just over 5 minutes in length. I am not totally inept but thought it would take 20 - 30 minutes but it took less than 15, and I even cleaned the floor while the fridge was pulled out. The video showed unplugging the ice maker but mine was hard wired so I did not have to. One reason I did not get this fixed when it first stopped working is I didn't want to pay the service call to diagnose and then for the repair. For about $60.00 I have a working ice maker. Thanks Parts Select!