ADB1100AWW5 Amana Dishwasher - Instructions

We had to pull the dishwasher out the get the heating element brackets loose underneath. We had to put the new heating element in and then we had to figure out which code to program in to make it reset. the last one listed on the installation instructions was the one that worked. I think it was heated dry, normal, heated dry. It would be very helpful if the reset instructions were put in the manual by whirlpool. I am very pleased with my part that I ordered from PartSelect. It came within 2 days of placing the order.

Removed unit from counter. Replaced element.

I remodeled my kitchen with new cabinets. In order to better utilize cabinet space, I located the dishwasher away from the sink, which means that I had to have a longer drain hose. The store I purchased the dishwasher from didn't have a longer hose, so I went online and found it on this website. Thanks for the quick shipment. I ordered it using standard delivery and received it in less than three days. I have book marked this website for future use.

Empty dishwasher remove bottom basket. Disconnect electricity then turn off water. Remove top screws from counter. Slide unit out and gently tip forward. Remove the two wires from connectors on element. Unscrew plastic nuts from element save if reusable. Gently tilt unit back to normal position. Remove old element and install new one and attach to stainless spacers to hold element in place. Tip unit forward. Reinstall plastic nuts. Plug wires back into new element connectors. Tilt back into normal position. Turn water back on check for any leaks and repair if necessary. Turn electricity back on and then slide unit back into original position and replace under counter screws. Test out by running quick cycle wash. It should function normally. During drying cycle open door to be sure it is hot inside. If hot then it is repaired. Let it finish cycle and replace basket. Do not touch hot element as it will burn you.

Using a Torx screwdriver, I removed the fasteners holding the control panel/latch section of the door on the dishwasher. I tested the high limit thermostat with a multimeter. Just two terminals, one being power in, the other power out. The part had what I have heard call a "high resistance open". In other words, the power was not getting from "A" to "B". Power in - not out. After cutting power to the unit, I removed the part (just pull it out of the retaining clip and pull the terminals from the part). After receiving the part...by the way, really fast delivery...I reconnected the part (it doesn't matter which wire goes where), pushed the part back into the retaining clip, replaced and fastened the control panel, then restored power to the unit. Runs like new.

Shut off water,power. disconnect water line,electric,drain.Pulled dishwasher out,laid dishwasher on it's back.Unplugged electric on pump,twisted pump out.Installed new pump and reinstalled dishwasher.

it was just a matter of snapping the new assembly in place.

put new one in