All Installation Instructions for Admiral Washer AAV7000AGW

Scrapping noise coming from washer machine is draining.

Remove all hoses and power supply tiled washer towards the front. By removing four screws to rear access panel on the back of washer to gain access to drain pump. Removing drive belt and releasing hose clamps. With socket wrench or nut driver remove three screws to remove pump from washer base. Replaced with new drain pump is a reverse to removing old pump.

Parts Used:

Washer Drain Pump

LLOYD from KNOX, IN
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers, Socket set

Was this instruction helpful to you?

Thank you for voting!

Plastic Hinge Broke

Just like the viedo said, release the springs holding the top, remove the screws and replace the hinge. Put the top back on by snapping back into place.

Parts Used:

Lid Hinge Pin

Bruce from Smithfield, VA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

hinge pin broke

was really easy. I watched the video and was done in less than 10 minutes. I read other stories and pushing the tub over and removing and installing the screws would have been very difficult. Opening the lid was very easy then the screws are right there in front of you.

Parts Used:

Lid Hinge Pin

Lid Hinge

Screw

Mike from Orrville, OH
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

swealing when emptying

unscrewed back cover 3 screws then unscrewed 3 screws holding pump, pulled off belt replaced pump, put screws on, and then belt, then turned on machine no problems, put back plate on and it worked ...great job , I did this with 1 are in a sling so that's why it took 1 hour..

Parts Used:

Washer Drain Pump

Martin P from Ridgeville, SC
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Washer leaked during spin cycle

Initially, it was uncertain how to remove the front panel. There were hidden clips that I was unaware of. But, the video on partsselect's website was excellent. It gave me the confidence exactly what to component to purchase and how to repair my washer. My repair was identical to the drain pump video and had no issues what so ever.

Parts Used:

Washer Drain Pump

Joseph from Warrington, PA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers

Was this instruction helpful to you?

Thank you for voting!

Washer would not spin and made a "clicking" noise with metal shavings in the area of the pump

Disconnected hoses and power cord, pulled washer into hall area, laid towels down to soak up any residual water and tilted washer onto its face or front side. Removed lower panel on back of washer with three screws to expose pump and hoses, removed belt from underneath, removed three screws from pump base with nutdriver and two hoses with spring clamps with pliers. Installed hoses with spring clamps with pliers, slid pump into place per alignment pins on the base, installed the three screws on the pump base with nutdriver, installed rear panel with three screws with nutdriver. Installed belt and titled into upright position, slid back into place, hooked up the hoses then cord and did a load of laundry just like it was new.

Parts Used:

Washer Drain Pump