91194404300 Kenmore Range - Instructions

Repair was very easy. Removed two nuts with nut driver and unhooked old element and new element slipped right on terminals. Replace nuts with driver and we were ready to go.

took off old heating element and replaced with new heating element. no appliance store in my area had the replacement element. googled heating element and found the site and ordered part. had part within 5 days.

Remove light bail, glass cover held by two nut screws. Pull socket, removed clips in back, replaced wire connectors, placed new socket in, then glass cover and bail. Wire connected in back, cover plate replaced.

The new drip pans are great. I had purchased generic ones locally that were supposed to be universal. The problem was that they did not fit right and the burner coils did not sit flat. The new drip pans fit well and look great too.

Never did a repair like that. Had to ask store clerk what you call that thing you take off bolts with. But repair went great. Very satisfied. Part arrived very quickly and saved our Christmas dinner. THANK YOU!

its easy take the plate off pull it out disconnect the leads i used locking pliers to hold the leads from going up into the insulation until i installed the element 10 min easy .

The drip pans arrived and she switched them out with the old ones Easy!

I ordered new drip bowls and put them in place. They fit just fine.

After searching the internet for a cause for the burner not getting hot it looked as though it was the burner switch. I ordered the switch and installed it. Behold it still did not work. I then ordered the burner, installed it and it worked. So I had a 50/50 chance as to which part was the problem. This was my first stove repair and I found it easy to do. Finding something to hold up the ceramic cooktop took the most time. I cut a piece of wood to prop it up while I replaced the burner.

replaced pans- what I would like to comment on is the time- I ordered one day at noon and had them the next day at noon- I live in tiny town on northern border of USA- it was awesome- I couldn't believe it was them- 24 hours- super job and excellent price too

Pull knob. Pull wires. Pull two screws. Replace switch

Unplug heating elements and pick up drip bowels and reinstall elements.

I ordered new oven racks. My old ones were the original with the range (uncleanable). I cleaned by oven till it shined and when I put in the new racks it looked like a new oven. I'm very happy.

Removed 4 screws from back panel, disconnected small electricsl connector from sensor, removed one mounting screw from sensor inside oven,pulled wires through and removed old sensor. Fed wires for new sensor through and connected electrical connector, installed panel, installed mounting screw on sensor and checked oven, worked like a champ. Took 5 minutes.

1. Unplug stove - Important step 2. Remove hexhead screws holding element in place. 3. Disconnect wires. 4. Get new part. 5. plug wires on new element. 6. attach element with hexhead screws in place. 7. Plug in stove. Test the burners, clock and oven to see that they are all working. Mine were not and then I remembered that I started at step 2 instead of 1 and shot sparks everywhere and tripped the breaker. So went and reset the breaker and everything worked fine. Remember always to do Step 1.