Models > 57731H8WW > Instructions

57731H8WW General Electric Washer - Instructions

All Instructions for the 57731H8WW
376 - 380 of 380
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
very good
ghanged the knob easy
Parts Used:
Control Knob and Clip - White
  • vance from van hornesville, NY
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Knob on washing machine had broken teeth and would not turn the timer.
Used needle nosed pliers to pull plastic clip off the back of the old knob. Pulled broken knob off. Put on new knob over the metal post. Put on the plastic clip back on the back of the knob to hold it in place.
Parts Used:
Dial with Compression Ring Timer Knob
  • Brian from Bloomington, IL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers
Was this instruction helpful to you?
Thank you for voting!
knob not turning/cracked inside
Pulled bad knob off. Found clip from bad knob still on and removed. Slid and aligned new knob on.
Parts Used:
Control Knob and Clip - White
  • Daniel from Glen Mills, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
timer and control knob
This repair is super easy. Take out the 6 phillips screws on the back of the control panel. Disconnect the timer wires and plug into the new timer--One wire at a time to make sure they fit into the same slots. Reinstall the timer and knob and back of the dryer and you are done. No need for a technican here. Save some $.
Parts Used:
Control Knob and Clip - White
  • Bob from MOUNT AIRY, MD
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Timer knob was stripped and would not advance the cycle either manually or automatically.
Pull the knob out on the machine, remove the plastic clip from behind the knob and take the knob off. Install the new clip halfway onto the new knob, put the new knob in place and set the clip all the way in. 5 minutes.
Parts Used:
Timer Knob
  • maryellen from troy, NY
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the 57731H8WW
376 - 380 of 380
Back to Top