Models > 4KSRS22QAA01 > Instructions

4KSRS22QAA01 KitchenAid Refrigerator - Instructions

All Instructions for the 4KSRS22QAA01
526 - 540 of 556
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Door was making noise when we opened and closed it
I watched the video on you tube and followed his instructions. It was very easy, it took about 20 minutes from start to finish.
Parts Used:
Door Closing Cam Kit
  • Sandra from Crown Point, IN
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Socket set
Was this instruction helpful to you?
Thank you for voting!
auger broke into pieces
part better than original just unscrewed and removed original. new one fit just right.
Parts Used:
Ice Auger Kit Ice Bin Auger Drum
  • Kenneth from Robertsdale, AL
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
The refrigerator would not defrost and would freeze up and no longer cool.
Turn off power to the frig. Remove the shelves and back brackets from the freezer, then with a 1/4" nut driver remove the nuts holding the rear metal panel in place. Once removed the defrost thermostat is right in front of you. You will have to clip the wires from the old t-stat because they are in a harness. Once clipped, strip the wires back, wire in the new t-stat, add wire nuts and put it all back together. Very easy job to do, works great. Thanks Parts Select, Mike.
Parts Used:
Bi-Metal Defrost Thermostat
  • Mike from Frankfort, IL
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver
Was this instruction helpful to you?
Thank you for voting!
Ice maker nozzle broke off
Removed front panel by inserting stiff putty knife at bottom and gently prying snaps loose. removed two screws holding electrical board. had assitant hold both out to one side without removing their connections or wires. Cut off old water line about three inches behind broken nozzle. Cut head off a small screw and used threads to connect cutoff old hose to new hose. Pulled both through door and out bottom until new hose appeared. Very easy.
Parts Used:
Nozzle and Tube Kit
  • joe from austin, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
icemaker not working
I followed vidio instructions, took about 15 minutes. Fridge making great ice cubes again. Felt prouud of the repair I did being 70 years old and a female. Thank you
Parts Used:
Ice Maker Water Fill Tube Kit
  • shirley from wind gap, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Nutdriver, Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
cracked seals
the speed of part delivery was amazing. using the instructions, posted on your web site, the installation was quite easy. without the instructions it would have taken much longer. thanks to all.
Parts Used:
Freezer Door Gasket Fresh Food Door Gasket
  • Anthony from Emmett, MI
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver
Was this instruction helpful to you?
Thank you for voting!
broken drum on the icemaker dispenser
followed the video and it went really fast.
Parts Used:
Ice Bin Auger Drum
  • Ralph from Camarillo, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Water fill tube was broke at the 90° in back of the frige
Water was already off. All I had to do was pull the fridge away from the wall, remove two screws that hold the fill tube onto the back of the frige, then remove the fill tube. Install the new fill tube, reinstall the two screws. Had to cut the water line straight and clean, slip on the new Compression nut and farrell and insert into the new fill tube, tighten-up, good-to-go.
Parts Used:
Ice Maker Water Fill Tube Kit
  • Douglas from Pahrump, NV
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Nutdriver, Pliers
Was this instruction helpful to you?
Thank you for voting!
Fridge stops cooling
Fridge would stop cooling, get way over temperature. I noticed it would start up again if I tapped near the thermostat. It would run for a while then stop again. Replaced the thermostat exactly as shown in video. Fridge works fine now.
Parts Used:
Thermostat Assembly
  • Daniel from Austin, TX
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
refig kept defrosting
all is fine now. thanks andy
Parts Used:
Thermostat Assembly
  • andrew p from white plains, AL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Crisper drawer bracket broken
pulled crisper drawer out plus drawer above. Removed old bracket & replaced with new part. Put drawers back in. Part was exact fit - no modifications required. Time was actually less than 5 minutes.
Parts Used:
Meat Drawer Cover and Shelf Frame
  • Barbara from Lewisberry, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
support for bottom drawer had broken
removed both drawers, glass. lifted old part up and out. set in new part. replaced glass and drawers........
Parts Used:
Meat Drawer Cover and Shelf Frame
  • john from santa ana, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
Was this instruction helpful to you?
Thank you for voting!
refrigerator not cooling but freezer worked well
watched the video followed the instructions and the repair took less than 30 mins. thank you parts plus for the video ref now workes properly and saved me a bundle of money
Parts Used:
Thermostat Assembly Door Light Switch
  • Vernon from Moorehead, KY
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
I googled refridgerator door does not close.
I found this part on PartSelect. I was so excited it also showed a video on how to fix the door. My neighbor said he would help me and I ordered the pkg. It took 3 days to get here since I ordered Friday night and the part arrived Tuesday , this was the Easter Sunday week end also. Well the video said it was easy to do and I think it said it would take 15 min. My neighbor had it fixed in 10 min. I could not be happier. Thanks Part Select and my neighbor Mike.
Parts Used:
Door Closing Cam Kit
  • Teddy I. from Madison, OH
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Nutdriver, Pliers, Screw drivers, Socket set, Wrench set
Was this instruction helpful to you?
Thank you for voting!
The floating baffle was cracked which prevented the metal ice crushers from going around.
I watched the installation on your web site and followed your directions and it fell right into place. Absolutely no problems. Thanks.
Parts Used:
Floating Baffle
  • Gilbert from Needville, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the 4KSRS22QAA01
526 - 540 of 556
Back to Top