Models > 3860ERS > Instructions

3860ERS Jenn-Air Cooktop - Instructions

All Instructions for the 3860ERS
106 - 108 of 108
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
bearing went out in blower motor
removed old motor from cooktop & motor housing & replaced w/ new motor & parts to install same. parts needed where screws & isolators (3).All went ok
Parts Used:
Blower Motor Exhaust Vent Blower Wheel
  • richard from white castle, LA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers, Wrench set
Was this instruction helpful to you?
Thank you for voting!
Missing ring/ bowl.
PS made finding an old bowl/ring adapter easy.
Parts Used:
Chrome Trim Ring - 8 Inch
  • Steven from Federal Way, WA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Two of the screw holes in the new tops do not line up with the holes in the existing pans.
I had to remove the clip attached to the edge of the pan holding the wires so I can push the top down more for the holes to line up. The thickness of the clip prevented the holes to line up.
Parts Used:
Cartridge Top - Stainless Steel Drip Bowl - Chrome - 8 Inch
  • HONESTO from HEMET, CA
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    1- 2 hours
  • Tools:
    Nutdriver, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the 3860ERS
106 - 108 of 108
Back to Top