2537480240H Kenmore Refrigerator - Instructions

Took longer to clear the top shelf to remove it from the refrigerator to do the repairs. Super easy!

removed shelf. took out screw. replaced support

Removed front low grill, removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the wires. Reversed process to install new timer.

Unscrewed the screw that held the suport rail to the shilf and changed the rail. Then I screw in the new rail.

first i removed the screw from the back of the shelf then pulled the old rail off. I sliped the new rail onto the post then replace the rear screw.

took 4 screws out of the discharge vent on top of the refrigerator section and unpluged the wiring harness and put the section on the counter and unscrewed the timer and put the new one in and reinstalled the assembly and plugged the Jack and put the 4 screws back in, and rotated the timer and put it on defrost removed the back and check the heaters and drain .

I unscrewed the old drawer support rail and installed the new one. The phone rep. was excellent. He listened to what I needed, looked up the parts for me, and sent me the correct parts the first time. I think the parts arrived within two days, much faster then I expected. I will be doing business with you again whenever I need parts. Thank you for your excellent service. You exceeded my expectations.

Sincerely,

Rob Ponitz

Very, very easy problem to fix. I took the shelf that the support rails were attached to out of refrigerator. Unscrewed broke piece and screwed in new support rail and simply slid shelf back into refrigerator. Ta~Da! If I can do it, you can do it!

First, remove shelf unit from refrigerator and lay glass side down on a large flat surface. Observe, then pay attention to assembly. Spent more time with this, drinking coffee, and playing with puppy, than the actual repair. Only had to remove and replace two
phillips head screws. Replace deli - meat drawer after shelf unit is in place in refrigerator. Check for clearance for door to close.

push it 'till it clicks.

I Removed the old broken piece and replaced it with the new drawer support, using the screwdriver it was a very simple operation.

Repair was quite easy. Simply remove screw and replace part. My repairman charges a min. fee of $99 to come by. I did this myself and saved an easy $100! The part came very quickly--next day after I ordered it. Would definitely do this again.

Super easy. We unscrewed the broken rail, and screwed the new rail into place. Much easier than expected!!! We were also pleasantly surprised to have the part arrive the day after we ordered it!

took off bad part-- 1 screw-- took every bit of 3 min. to change

I unscrewed the old drawer support and screwed the new one in. It was very simple!