11088732798 Kenmore Washer Dryer Combo - Instructions

Open lid,remove softener cover on agitator[grip and pull-up gently] [inside] grip and pull-up on softener dispenser cap with seal,you see the bolt,fit a 7/16 or a 11mm socket on your extension and remove the bolt,reach in and lift unit out gently,place on workbench/area or floor and gently but firmly remove top portion then with thump and index finger push out on the two small tabs[or one at a time]to reliese the agitator.[broken dogs inside,remove and clean]a small rubber "O"-ring is below,replace with a little silicone grease to keep in place and on the contact surface and metal spline for the agitator.place all four dogs in the kit[hold up-side down{dogs will not fall out}sliding top portion over and lock in the two tabs.you are now ready to reassemble.

The cam kit itself did not fit. However, the dog ears could be swapped out. It's cheaper to buy the set separately, they're fairly universal. Part number: PS388034

Simply put it in the exhaust hole.

Removed water softner holder. Pulled plastic seal out from agitator by hand. Removed bold that holds agitator to drive shaft. Pulled out part that holds dogs. Replaced dogs and reversed repair order.

I just changed for the new one! 2 seconds.

very easy to repair , instructions very clear , parts person very good to talk to, parts got here fast

Easy Repair!! Remove the Fabric Sofetener dispenser from the top of the agitator. Beneath that, remove the plastic cover over the cam assembly. Use an 11mm socket to remove the agitator. After removal, pull it apart to reveal the cam. simply replace the dogs and reverse the process to reassemble. NOTE: YOU MAY NEED A LONG SOCKET EXTENSION TO GET DOWN INTO THE 11mm BOLT.

part fit perfect

I just unscrewed the top agitator cap and slid the o-ring on and put it back. Done in seconds.

Removed back cover of entire dryer.The thermostat was accessible from that point(Just as diagram showed), removed two wires from thermostat, removed thermostat & replaced with new thermostat & plugged 2 wires back in just as instructions indicated. Very simple,15 minute job. I will certainly use again for any appliance repairs.

I originally thought it was the heating element but I ruled that out after I took it off and looked at it. After that I took a volt o meter to check the high thermostat and low one also but both had power going to it. Once that was done I did the thermal limiter fuse and it was blown. All I had to do was unplug the dryer, take the back off of the dryer, then take two bolts out and replace the part it was so easy. Thanks for the part.

After removing the front of the dryer it was evident that the blower boss had broken where the motor shaft comes through and is attached. I removed a few more parts to make the blower more accessible and removed it. I then machined a new boss and attached it to the blower and reinstalled it.I then did a quick continuity check on the three thermostats since the dryer was already apart.I discovered one was faulty and ordered a new one from you.That repair took all of five minutes.The irony of the whole thing is that while I was ordering the thermostat from you,I asked out of curiosity,if the blower was still available. As it turns out it still is but the new machined part worked out great and the dryer was back up and running in no time.

Thanks again,
Dave

the repair itself went reasonably well, following the instructions that you provided, but it still isn't working well. Is it possible that I put it in upside down?

ordered wrong limit switch had to reorder right switch and decided to replace the heater element as well. works fine now

Stuck it in, done. The really good thing was your website - the BEST I've ever used to order anything on the web, bar none. SO clear, SO organized, SO logical, SO easy to use. I just wish other companies using the internet to sell things would learn from you guys. Kudos to you and your webmaster, really outstanding.