10660162990 Kenmore Refrigerator - Instructions

Removed the old one. The new one had a power chord attached but it did not connect to the wire in the freezer. I saw it could be unplugged from the new ice maker and the power chord from the freezer plugged right in. Once installed, was not sure it worked but after a few hours it filled with water and started making ice. Works great now.

I installed the new icemaker that was missing the shutoff arm then I ordered the arm from you and installed it. End of story.

The icemaker came with very easy to understand instructions the installation took less than 45 min. that included installing the selinoid valve and waterline I had a nearby waterpipe, the acual icemaker took about 5 min. to install it in the freezer.

I have a side by side so the space to work in was limited but I still completed the install in about 30 minutes. Unplugged the refrigerator then loosened the top two screws took out the bottom screw lifted the ice maker out just far enough to disconnect the power cord reversed the procedure. plugged it back in started making ice in 30 minutes. Probably would have not have taken that long my MS slowed me down a little. The repair man was going to be $300.00 plus $$75.00 trip charge what I paid was $128.41 that was with 3 day shipping.

Turned off the water to the ice maker; disconnected the wiring harness to the ice maker; unscrewed it from the freezer (two screws). Unhooked the ice lever bar, opened up the motor assembly. Switch the motor out (two screws). Installed in reverse order.

Pulled out the icemaker. Switched out the Motor Assembly (so easy) and woke up the next morning with ice. Our ice dispenser wasn't working either. This repair inspired me to take the ice dispenser apart and I found that the lever arm wasn't touching the contact when pressed. We now have ice and a working ice despenser. Oh yeah--my wife was so impressed. The part came in on time and it was very very easy to replace.

unplug frig, didnt turn off water used cord light to see. Took 1/4 nutdriver and loosen screws removed screw on bottom bracket uplugged ice maker. reversed the process for the new one and done

Shut water off to stop leak. Purchased new valve but it had different size fittings. Proper hardware was not included with the new part and was not available from PartSelect or Whirlpool, the maker of KitchenAid. I'm a paraplegic so my brother came over after I got the parts and the hardware. He was able to install the valve but it didn't work while he was here so he shut off the water supply and I'll have to wait and see if it works some other time. Until then, looks like I'll be using trays.