Husqvarna Lawn Mower Seals and Gaskets

Your Price

$5.71

PartSelect Number PS9294808

Manufacturer Part Number 692236

This OEM exhaust gasket in lawn and garden equipment creates a seal between the engine block and the muffler or exhaust pipe so that exhaust gases do not leak. This is 3.30cm in diameter and 6.35cm in length. Your machine may have a loud hissing or popping sound coming from the exhaust area if the gasket was faulty. You may also notice the presence of black soot around the gasket or the exhaust. Your gasket needs to be replaced if it appears worn or deformed. Otherwise, your machine will experience exhaust leaks. To detach the gasket, remove the fasteners that secure it using a socket or wrench. You can detach the gasket from your machine afterwards. Please bear in mind that this replacement part is sold individually.

Installation Instructions

paul from VADER, WA

replaced worn parts

took old off, put new on Read more...

Your Price

$37.66

Husqvarna Lawn Mower Crankcase Gasket With Bolts

PartSelect Number PS11829358

Manufacturer Part Number 594195

This genuine crankcase gasket is used on small lawn and garden engines. Its purpose is to make an air tight seal so that no air/oil leakage occurs. Over time this gasket will deteriorate and will need to be replaced. It is made out of composite material and it is sold individually. To complete this repair you will need a wrench. Includes one (1) gasket and ten (10) bolts. This will need to be tightened with torque to 300 inch pounds.

Installation Instructions

rodney from MUSCATINE, IA

governor not working

Had to pull the engine off the rider mower. Drained the oil took shield off the flywheel. Set it upside down on a 5 gal bucket. Took a 7/16 hand wrench to remove governor lever from bottom of engine. Left it in its location. Pulled 10 1/2 " bolts. Split engine case. Found the old governor had broke into pieces. Had to use a magnet to remove all the pieces. Removed the small clip and removed gear. Lubed shaft slid new on put new clip on. Lined governor weights with center piece tapped it in place very lightly. Cleaned gasket flanges pulled the shaft seal. Used the old seal as a seal driver. When putting the cover back on make sure the seal dont roll out. Take a mini screwdriver and tuck it in around shaft. Put bolts back in and tighten like instructions Read more...