Ask our experts a question about this part and we'll get back to you as soon as possible!
1 question answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Janet
December 28, 2021
the oven was overheating and based on gas fitter suggestion, I just replaced the circuit board but it's still overheating. Could it be a faulty temperature sensor? If so, will I need to attach a new sensor directly to the circuit board?
For model number HDI7052C
Hello Janet, Thank you for your inquiry. You can test the sensor with a multimeter to see if it is the issue. If you are unfamiliar with how a multimeter functions, we have videos available to assist you. To install the new sensor, remove the rear panel and disconnect the red connector on the sensor wire. Then go to the inside of the oven and remove the two screws and take out the sensor. Put in the new sensor, rethread the screws and plug the sensor back in at the back of the stove, then you can replace the rear panel. Good luck with your repair.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
