Ice Maker Assembly,Kit AEQ36756912

Hi Harry, Thank you for your question. If there is water leaking from the ice maker, the issue may be with the water inlet valve. If a component in the water inlet valve has failed, it will prevent the valve from working correctly. You should also check the ice maker and the tubing connected to it to make sure everything is fitted correctly. To test the water inlet valve, you will need to use a multi-meter. To check the water inlet valve, unplug your refrigerator, disconnect the water supply and locate your water inlet valve. It is usually on the rear of the refrigerator, near the bottom. You will need to remove the rear panel to access it. Inspect the valve inlet supply connections for leaks and tighten or replace the connectors. You should also inspect the valve body for any cracks or damage Check the outlet tubing for cracks or abrasions that may also create a leak and replace any cracked or brittle tubing and connectors. If none of the above appear to be the cause of the leak, remove the water inlet valve from the unit. Using a multi-meter on the Rx1 setting, test your valve for continuity by placing the probes on the valve’s terminals. You should receive a reading of 200 to 500 ohms. If you receive any other reading, you need a replacement water inlet valve. To test the ice maker, disconnect your appliance from both the power source and water source. Inspect the fill tube and the fill cup area at the back of the icemaker to make sure that they are not frozen. If there is an ice buildup in that area, confirm no foreign objects have disrupted the flow of water into the fill cup. Inspect the outlet tubing from the fill valve to the ice maker fill tube for any signs of restrictions. If any issues are found while performing the checks above, you will may a replacement ice maker assembly. If nothing obvious has caused the ice buildup, then suspect the inlet valve or tubing. If you are not familiar with how to use a multi-meter, here is a link to one of our videos on YouTube that you may use as a general reference to show you how to use one, https://www.youtube.com/watch?v=bWC44fHn0As. We hope this helps. Thank you and have a great day.

Hi George, Thank you for your question. If your ice maker is not making ice, there are some parts that you will need to check to see which one is causing the issue. You will need to check the water fill tubes, the water inlet valve, the water filter and the ice maker. We have included a link that you may reference on how to check these parts. Once you have determined the part you need, please feel free to call customer service. We are open 7 days a week and anyone will be happy to assist you. We look forward to hearing from you!

Hi Michael, thank you for reaching out. According to our research on the model, the Ice Maker Assembly appears to be faulty and you may need to replace it with part number PS3532295. If you need help placing an order, customer service is available 7 days a week. Glad to be of help!

Hello Joe, Thank you for the question. If the Dispenser was opened up and verified the Flap, Lever or the spring are not loose or damaged, you may have a defective Dispenser Control Board, PartSelect Number PS3533949. We hope this helps!

Hello Sandra, Thank you for the question. We suggest checking the Springs and Clamps for the handle to make sure they are intact. We also suggest changing the handle and Handle Bar for damage or wear. We hope this helps!

Hello Doug, Thank you for the question. If the Ice Maker was installed and not making ice After 24 hours, we suggest testing the Water Valve with a Multimeter. The valve has a solenoid for the Ice Maker and one for the dispenser. Set your multitester to the R X 1 ohms setting to test for continuity. Place each of the multitester's leads on a terminal. Your multitester should display a reading between 200 and 500 ohms. Closely examine your water inlet valve. The exact ohm resistance rating you should test for may be marked on the valve. We hope this helps!