Frigidaire/Frigidaire_Thumb/QL0INHRB.gif
See part F119 in the diagram
( Grid squares measure 1x1 inch )

Get in touch, we're here to help!

Open until 12am EST

customerservice@partselect.com

Limit Thermostat For Cooling Fan

★★★★★
★★★★★
1 Review

Get this part fast! Average delivery time for in-stock parts via standard shipping: 1.8 days.

PartSelect Number PS3409411
Manufacturer Part Number 318578506
Manufactured by Frigidaire
Troubleshooting
This part fixes the following symptoms:
Little to no heat when baking
This part works with the following products:
Wall Oven, Range, Microwave, Microwave Oven Combo.
This part works with the following products:
Frigidaire, Kenmore, Electrolux.
Part# 318578506 replaces these:
AP4587847, 318578501
Questions and Answers

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

10 questions answered by our experts.
    Sort by:
    Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
    Sunil
    November 28, 2018
    My oven does not heat up. Stays on 100f. I took the high range thermostat (318578506) out and tested its resistance and got 0.3 something ohms. So figured it was good. After i put it back the oven works. Then weeks later the same issue. I removed the thermostat again and put it back and it works again. Any ideas?
    For model number FFEC3024LB
    Hello Sunil, Thank you for the question. With the sensor at room temperature, measure the resistance between the two prongs at the end of the sensor connector. The resistance of the sensor should read approximately 1080 – 1090 ohms at room temperature. Hope this helps!

    4 people found this helpful.

    Was this helpful?
    Thank you for voting!
    Barbara Perreault
    November 6, 2018
    I replaced the temp sensor it didn't need to be thought that was the problem but the temperature does not stay hot i do pre heat i got to bake and then the temp takes a while to get there and when it does the tempurature drops and doesn't cook it just drops down what is wrong and what part do i need to replace the tempurature control itself not the sensor ??
    For model number FPES3085KFF
    Hello Barbara, thank you for your question. If the sensor was replaced and didn't fix the issue the control board should be replaced. That is part number Electronic Control Board Part Number: PS2368654.

    3 people found this helpful.

    Was this helpful?
    Thank you for voting!
    Paula
    January 2, 2018
    Is there a thermal circuit for this oven, fuse or a switch? After self cleaning my oven won’t heat past 100 degrees.
    For model number EW30EW65PSB
    Hi Paula, Thank you for your question. There is no separate fuse from what I am seeing underneath your model information. I would suggest checking your elements, and your temperature sensor inside of your oven with a multi meter. The elements should read anywhere between 0 - 50 ohms of resistance and the temperature probe should read anywhere between 1000 - 1100 ohms. If all three of those parts are working inside of your oven, then you may want to check the control boards on your appliance. Good luck with your repair.

    2 people found this helpful.

    Was this helpful?
    Thank you for voting!
    Ed
    March 1, 2019
    The cool down fan continues to run, has been running all night, what needs to be done?
    For model number oven model 790.48783901
    Hi Ed, Thank you for your question. The cool down fan will run until the area around the microwave has cooled. Units over a range or oven may automatically turn on the exhaust system when the area around the microwave becomes too hot. The exhaust system cannot be shut down until the temperature returns to a safe level. If it is not turning off and the area around the microwave is cool, then you will need to check the thermostat, the control board and the door switches to see if they are causing this issue. I hope this helps. Thank you and have a great day!

    1 person found this helpful.

    Was this helpful?
    Thank you for voting!
    Jean-Marc
    January 25, 2022
    Does that piece will fix the problem of a cooling fan who never stop? Thanks
    For model number CGES3065KF6
    Hello Jean-Marc, Thank you for the question. Normally this would indicate the Thermostat is faulty. it can also be tested. With the sensor at room temperature, measure the resistance between the two prongs at the end of the sensor connector. The resistance of the sensor should read approximately 1080 – 1090 ohms at room temperature. We hope this helps!

    Was this helpful?
    Thank you for voting!
    Serge
    April 8, 2022
    Hi, I have a « clunking » sound like the one I hear when turning on my stove, it is the coolong fan starting. But to hear this sound even when I am not using the stove is not normal, could this be a faulty cooling fan, relay, cooling fan thermostat???? Thanks for helping me pinpoint the problem.
    For model number CGES3065KF5
    Hi Serge, Thank you for your question. If the oven was recently used and you are still hearing the cooling fan, this is normal. The fan will stay on until the oven has cooled. If it is coming on by itself, then a relay for either the bake or the broil element has shorted out on the electronic control board or the contacts on the oven cooling fan thermostat are stuck closed. You will need to check these parts to see which one is causing the issue. Once you have determined the part you need, please feel free to call customer service. We are open 7 days a week and anyone will be happy to assist you. We look forward to hearing from you!

    Was this helpful?
    Thank you for voting!
    Related Parts:
    Warren
    November 26, 2019
    The top oven of my double wall oven setup isn't working properly (its not maintaining temp), the first thing i thought it was the thermostat to which i realized what i was looking at was the temperature sensor. I recently replaced the temp sensor and the top over is still not heating up, i set both ovens to the same temp at the same time and when i checked on after 20min bottom was around 280 while the top is around 147. What i did notice is that the exhaust fan for the top oven was blowing real hard as if its cooling down the oven when it should be heating up. The question is would replacing the actual thermostat fix this issue? In the diagram i am seeing only seeing 1 thermostat, is only one needed to control both ovens or 1 for each? If its not the thermostat would it be the chip board, whats throwing me off if its only 1 thermostat controlling 2 ovens wouldn't both ovens not heat properly? Thanks
    For model number FFET3025PSD
    Hello Warren, Thank you for your question. If you already replaced the temperature sensor for the upper oven, then it is likely that it is a faulty control board and the control board would need to be replaced, yours is under part PS1528196 for your model. Hope this helps!

    Was this helpful?
    Thank you for voting!
    Related Parts:
    Lance
    December 23, 2019
    I set oven at 350 and it comes up to temp. Display stays at 350 but temp drops. I hit "convection" enter "350" and it shows oven temp as low as 250. I push start and it comes up to temp only to fall again.
    For model number FGET3065PFC
    Hello Lance and thank you for writing. It certainly sounds like a faulty temperature sensor PS1175815 and/or bake element PS3655318you should check for signs of damage, and replace it if needed. We hope this helps. Please contact us anytime.

    Was this helpful?
    Thank you for voting!
    Related Parts:
    Shaun
    February 1, 2020
    Hi. My frigidair stove is showing error code f30. The probe, wiring and control panel checks out good. Will the high limit switch produce this code. Thanks
    For model number fridigdair stove CGDS3065KF7
    Hello and thank you for writing. The F30 and F31 codes differ slightly, even though they both indicate a problem with the oven temperature sensor. Specifically, the F30 code indicates the probe could be broken or unplugged or its wires could be broken or damaged. In rare cases the high limit thermostat can cause this, more likely is a faulty main terminal block PS471605 or the wiring connected to it. We hope this helps. Please contact us anytime if you require further assistance.

    Was this helpful?
    Thank you for voting!
    Related Parts:
    Paul
    December 22, 2021
    No heat when oven on I metered cooling fan sensor no ohms. I bypassed sensor have heat in oven .then put sensor by a electric baseboard heater for 10 minutes metered sensor have 10 ohms is it sensor or ?
    For model number 79048789901
    Hello Paul, Thank you for your inquiry. The oven temperature sensor should be tested a room temperature and should read between 1000-1100 ohms. If it does not, then the sensor is faulty and needs to be replaced. An oven thermostat, should read 0 or close to 0. Any other reading, and it will need to be replaced. Good luck with your repair.

    Was this helpful?
    Thank you for voting!
    Related Parts:
      Customer Repair Stories
       Average Repair Rating: 3.8 / 5.0, 1 reviews. What's this?
        Sort by:
        Sorry, we couldn't find any existing installation instruction that matched.
        Thermostat for oven cook elements. Cooling fan is a misnomer-the fan still worked!
        First of all I am not Betty, I am her husband. Second I and a friend pulled the range out of the countertop (which was not necessary). The top can be raised on it hinges and the plate under the burners can be removed by taking out 8 to 19 screws and there is the thermostat looking at you. After doing this once and knowing where the thermostat is, the job could be done in less that an hour.. INSTRUCTIONS: Turn OFF the circuit breaker. Remove the burners. Remove the plate under the burners. Change the thermostat (making sure to place in correct direction as the one removed). Reassemble, turn on circuit breaker, test oven heat.
        • Betty from OLIVE BRANCH, MS
        • Difficulty Level:
          Very Easy
        • Total Repair Time:
          1- 2 hours
        • Tools:
          Screw drivers
        2 of 3 people found this instruction helpful.
        Was this instruction helpful to you?
        Thank you for voting!
          Customer Reviews
          Average Rating:
          ★★★★★
          ★★★★★
          1 Review
          1.0
          Filter By Rating:
          • 5 Stars
            0
          • 4 Stars
            0
          • 3 Stars
            0
          • 2 Stars
            0
          • 1 Star
            1
            Sort by:
            Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
              Model Cross Reference
              This part works with the following models:
              PartSelect Number: PS3409411
              Manufacturer Part Number: 318578506
              Brand
              Model Number
              Description
              Frigidaire
              20462033A
              Range - Range
              Kenmore
              79031033803
              Range
              Kenmore
              79031053000
              Range
              Kenmore
              79031062100
              Range
              Kenmore
              79031063100
              Range
              Kenmore
              79031069100
              Range
              Kenmore
              79031073100
              Range
              Kenmore
              79036902901
              Range
              Kenmore
              79036902902
              Range
              Kenmore
              79036902903
              Range - GAS RANGE
              Kenmore
              79036902904
              Range - GAS RANGE
              Kenmore
              79036902905
              Range - GAS RANGE
              Kenmore
              79036903901
              Range
              Kenmore
              79036903902
              Range
              Kenmore
              79036903903
              Range - GAS RANGE
              Kenmore
              79036903905
              Range - GAS RANGE
              Kenmore
              79036904901
              Range
              Kenmore
              79036904902
              Range
              Kenmore
              79036904904
              Range - GAS RANGE
              Kenmore
              79036904905
              Range - GAS RANGE
              Kenmore
              79036909901
              Range
              Kenmore
              79036909902
              Range
              Kenmore
              79036909903
              Range - GAS RANGE
              Kenmore
              79036909904
              Range - GAS RANGE
              Kenmore
              79036909905
              Range - GAS RANGE
              Kenmore
              79036932901
              Range
              Kenmore
              79036932902
              Range
              Kenmore
              79036932903
              Range - GAS RANGE
              Kenmore
              79036932904
              Range - GAS RANGE
              Kenmore
              79036932905
              Range - GAS RANGE

              Get in touch, we're here to help!

              Open until 1am EST

              Contact Customer Service