Detergent Dispenser - No Sensor WD12X24058 | Official GE Part | Fast Shipping | PartSelect
https://partselectcom.azureedge.net/Schematics/GE/00139555i01.gif

Detergent Dispenser - No Sensor

PartSelect Number PS12295245

Manufacturer Part Number WD12X24058

Manufactured by GE

Troubleshooting

This part fixes the following symptoms:

Will not dispense detergent | Door latch failure | Not cleaning dishes properly

This part works with the following products:

Dishwasher.

This part works with the following brands:

General Electric.

Part # WD12X24058 replaces these:

WD12X10415, WD12X21054, WD12X22515, WD12X22576, WD12X23539.
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
Sort by:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer Repair Stories
Average Repair Rating: 3.1 / 5.0, 5 reviews What's this?
Sort by:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Dennis from LAS VEGAS, NV
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers
Parts Used:
WD12X24058
The detergent tray wouldn't open during wash cycle
1. Pull out dishwasher (not all the way) 2. Open the door. 3. Remove the white rope holding the door hinge (both sides) 4. Remove the door by pulling up when the door is open about 4-8 inches. 5. Lay the door on the floor ( put something under the door so not to scratch the front. 6. Remove the small bolt at the bottom of the door (both sides). 7. Slide the hinge back, up, then out. 8. Where the hinges were are another set of bolts, remove those (both sides) 9. Grab the top part of the door (the part with the buttons) and slide apart. 10. Remove the styrofoam carefully. 11. Disconnect the wiring harness. 12. Remove the 6 screws holding the Despenser tray in place. 13. Put in new Despenser tray and put everything back together.
16 of 19 people found this instruction helpful.
Was this instruction helpful to you?
William from TIONESTA, PA
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Socket set
Parts Used:
WD12X24058
Soap dispenser would not function, wouldn't open.
Took cover of door off. Removeddoor from frame 1st. Lift door off of hinge. Disconnect door from springs. Unscrew bottom screws at base of door. Lift front cover(actually slides down) remove old part replace with new.make sure unplug door from main body.
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Maurice from SAN JOSE, CA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
Parts Used:
WD12X24058
Dispenser no longer opened during wash cycle
Very straight forward. After removing the power source the dishwasher was pulled forward enough to access the the door hinge springs. Then the door could be removed and the inner skin separated to access the the dispenser mounting screws.
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Stephanie from Huntsville, AL
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Pliers, Screw drivers
Parts Used:
WD12X24058
The soap dispenser was not opening during the washing cycle
Took off the door and separated the two door pieces. Unscrewed the old dispenser and replaced it with the new one.
3 of 4 people found this instruction helpful.
Was this instruction helpful to you?
LaRay from PRESCOTT, AZ
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers
Parts Used:
WD12X24058
soap did not dispense correctly
Followed video instructions step by step.
I was fortunate i had enough slack in water, electric and discharge lines to avoid disconnecting.

Two wrinkles
1. wire clips on my door had to be pulled/pried loose from door and there were two not one

2. could not slide dishwasher out after lowering adjusters and figured out it was the mounting tabs bumpimng the granite countertop, thus the use of putty knives to slide the dishwasher out.
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Customer Reviews
Average Rating:
18 Reviews
4.8
out of 5
Filter By Rating:
  • 5 Stars
    15
  • 4 Stars
    3
  • 3 Stars
    0
  • 2 Stars
    0
  • 1 Stars
    0
Sort by:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Model Cross Reference

This part works with the following models:

PartSelect Number: PS12295245
Manufacturer Part Number: WD12X24058
Brand
Model Number
Description
General Electric
ADT521PGF0BS
Dishwasher
General Electric
ADT521PGF0WS
Dishwasher
General Electric
ADT521PGF2BS
Dishwasher
General Electric
ADT521PGF2WS
Dishwasher
General Electric
ADT521PGF4BS
Dishwasher - DISHWASHER
General Electric
ADT521PGF4WS
Dishwasher - DISHWASHER
General Electric
ADT521PGF6BS
Dishwasher - DISHWASHER
General Electric
ADT521PGF6WS
Dishwasher - DISHWASHER
General Electric
ADT521PGJ0BS
Dishwasher - DISHWASHER
General Electric
ADT521PGJ0WS
Dishwasher - DISHWASHER
General Electric
ADT521PGJ2BS
Dishwasher - DISHWASHER
General Electric
ADT521PGJ2WS
Dishwasher - DISHWASHER
General Electric
DDT575SGF0BB
Dishwasher
General Electric
DDT575SGF0WW
Dishwasher
General Electric
DDT575SGF5BB
Dishwasher - DISHWASHER
General Electric
DDT575SGF5WW
Dishwasher - DISHWASHER
General Electric
DDT575SGF6BB
Dishwasher - DISHWASHER
General Electric
DDT575SGF6WW
Dishwasher - DISHWASHER
General Electric
DDT575SGF7BB
Dishwasher - DISHWASHER
General Electric
DDT575SGF7WW
Dishwasher - DISHWASHER
General Electric
DDT575SGF8BB
Dishwasher - DISHWASHER
General Electric
DDT575SGF8WW
Dishwasher - DISHWASHER
General Electric
DDT575SMF0ES
Dishwasher
General Electric
DDT575SMF5ES
Dishwasher - DISHWASHER
General Electric
DDT575SMF6ES
Dishwasher - DISHWASHER
General Electric
DDT575SMF7ES
Dishwasher - DISHWASHER
General Electric
DDT575SMF8ES
Dishwasher - DISHWASHER
General Electric
DDT575SSF0SS
Dishwasher
General Electric
DDT575SSF5SS
Dishwasher - DISHWASHER
General Electric
DDT575SSF6SS
Dishwasher - DISHWASHER