Lid Lock Assembly DC34-00025E

Hi Joe, Thank you for the question. The only way to know for sure is to test the switch you have with a multi meter to check for resistance. Hope this helps!

Hello Kathy, Thank you for the question. The dc error code on a Samsung washer indicates the washer will not spin because the load is unbalanced. You can redistributing the weight of an existing load, removing items to reduce the overall weight in the washer, or check the Damper Suspension Rods. We hope this helps!

Hi Kathy, Thank you for your question. If the washer is not spinning and the lid is not closing correctly, then the issue is likely the lid switch. The lid switch on a top load washing machine is used as a safety device to prevent the motor circuit from operating when the lid is open. If the lid switch fails, the washer may not spin. The lid switch is normally located beneath the main top with a projection on the lid or a pin attached to the lid that will actuate the switch when the lid is closed. Verify that the switch is being activated mechanically and that any levers or actuators are not damaged or sticking. If the switch is being activated, but there is no power being supplied to the motor, then the switch may be defective. Before testing the lid switch, please unplug the washer from the electrical outlet. Check the levers and actuators to ensure they are not damaged or sticking. If it is being operated mechanically and no issues were found with the levers or actuators, remove the switch from the appliance, set your multimeter to Rx1, and touch the probes to the terminals. You are testing for continuity and should receive a reading of zero. If your test results do not match those above, you will need a replacement lid switch. Also check and make sure that the lid is positioned correctly, so that it is activating the lid switch when it is closed. We hope this helps! If you have any questions, please let us know.

Hi Val, thank you for contacting us. According to our research, the lid lock assembly, part number PS12072637, is a complete lock with an attached wire and a clip that connects to the noise filter clip in the control panel of your washer. If you require assistance to place an order, please contact customer service!

Hi Cr, thank you for your question! It appears that your washer may have a damaged lid lock assembly, part number PS12072637. We hope this helps, good luck with this repair!

Hello Laura, thank you for reaching out. This error code is related to the door issue. You need to make sure the door is completely closed and that nothing is trapped in the door. We suggest you replace the lid lock assembly, part number PS12072637. We hope this sorts out your problem!