Part Location Diagram of WP33002789 Whirlpool IGNITER ASSEMBLY
See part 29 in the diagram
( Grid squares measure 1x1 inch )
Customer Service Representative

Get in touch, we're here to help!

Monday to Saturday
8am - 9pm EST

customerservice@partselect.com

IGNITER ASSEMBLY WP33002789

★★★★★
★★★★★
1 Review

Rated by 1 customer 

Easy 

1- 2 hours 

Ratings submitted by customers like you who bought this part.

$ 66.82
  In Stock
Get FREE EconoShip on orders over $100! T&C apply

Get this part fast! Average delivery time for in-stock parts via standard shipping: 1.8 days.

Does this part fit my model?

Need help finding your model number?
PartSelect Number PS11741122
Manufacturer Part Number WP33002789
Manufactured by Whirlpool
Product Description

IGNITER ASSEMBLY Specifications

This part ignites the gas within the dryer.
How Buying OEM Parts Can Save You Time and Money

How Buying OEM Parts Can Save You Time and Money

Troubleshooting
This part works with the following products:
Dryer, Washer Dryer Combo.
This part works with the following products:
Maytag, Samsung, Amana, Inglis.
Part# WP33002789 replaces these:
AP6007994, 33002789, 35001100, DC47-00022A
Back to Top
Customer Reviews
Average Rating:
★★★★★
★★★★★
1 Review
3.0
Filter By Rating:
  • 5 Stars
    0
  • 4 Stars
    0
  • 3 Stars
    1
  • 2 Stars
    0
  • 1 Star
    0
Sort by:
  • 1
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
  • 1
Customer Repair Stories
 Average Repair Rating: 2.8 / 5.0, 1 reviews. What's this?
Sort by:
  • 1
Sorry, we couldn't find any existing installation instruction that matched.
Heat for 1 minute then no heat
In my case, it was the solenoids. Take off the top be removing two screws on back, then slide the top back and off. Then remove little screws on top that hold the plastic bar with the electronic controls. This very easily will pop up, don’t unplug it, just lay it aside on top of machine. Under this you can see the white metal piece that contains the door. This whole piece comes off with the door in place. Look for four screws across the top, remove em. Then open the door, there are two facing out about 10 inches apart. Remove em. Now slide whole door out (sort of a hinge on the bottom) from the top. After it pops out from the tops, lean it out about 1 foot then pull up hard. It comes off at the bottom. Gently unplug the door, you will see the wire to unplug. I used a small screwdriver to gently pry the plug apart to get it started. After the front panel is removed, you can see the gas valve lower right. On top of the gas valve which is about 5 inches by 5 inches, you will two black cylinders on top of it. Cylinders that are 1.5 inches tall and about 1 inch wide. These are your solenoids. These create an electromagnetic field that opens the gas valve. There is a silver colored piece of metal on top of them holding them in place with two screws on top. Take this cover off the two black solenoids (Black cylinders). Then remove the cylinders after gently unplugging them. Do not just pull on the wires. Use an ohm meter to test the old ones after you slide them up and off what looks like a silver post. There are two metal tabs on one where the plug plugs onto it. Set your ohm meter for 1000 and touch the two metal tabs. Your meter should say there IS a circuit. If your meter says there is no circuit your solenoid is bad. The other solenoid has threee tabs. Hold your solenoid with the metal plugs down and the cylinder is standing upright. Have the three prongs facing you. The prong on the left as you face the solenoid it is your common. Touch this prong and then with the other wire touch the middle prong. You need to see a circuit that is closed, or connected. If there is no circuit your solenoid is bad. Now touch your two testing wires on the two outside prongs. You still need to see a circuit. If no circuit you have bad solenoid. Replace em. The solenoids die slowly over years. Your dryer will start to take longer to dry. This is sign of dying solenoids. To the left of the gas valve you can see the sensors that determine if the air coming out of the dryer is damp or dry. Replace them at the same time. Where you are the burner, on the left of the 5 inch wide tube it is in you will see a sensor, rectangle shape 2 inch by 1 inch. This determines if the lighter is glowing. Replace it at this same time. On top of the burner tube, top right, hard to reach, there is another sensor that shuts it all down if it is over heating. There are two wires plugged into it. Use a MAGNETIC and very short philips head to remove it. Slowly, don’t drop the screws. Pull the whole sensor out while plugged in, then unplug it using a screw driver to help get it started unplugging. When the new sensor goes in, screw it on place first. Do not try to screw the new one in with wires on it. It is not easy, but you can do it. Use a small flash light etc to help see. Once screwed on, plug in your wires. It does not matter which wire goes on which end. So after you replace all your sensors (4 total) and you replaced those two round black solenoids, you can put it all back together.

Do not buy cheap piece of sh-t parts. The cheap ones are made in China with short cuts, low quality metal and ceramics. Cheap. Use authentic Maytag parts, each sensor should be like $30. I replaced all of mine for $180. I now have a brand new unit as far as the electronics are concerned, good for another 10 years.
Other Parts Used:
Thermistor High Limit Thermostat Thermostat Dryer Radiant Flame Sensor IGNITER ASSEMBLY
  • Ted from TOPSHAM, ME
  • Difficulty Level:
    Easy
  • Total Repair Time:
    1- 2 hours
  • Tools:
    Pliers, Screw drivers, Wrench set
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
  • 1
Questions and Answers

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

2 questions answered by our experts.
Sort by:
  • 1
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Mike
April 26, 2018
I have a dryer that's been converted to use propane instead of natural gas. Do i need a specialized igniter to use one source over the other? Thanks
For model number MDG16PDDWW
PartSelect logo
Hello Mike, thank you for your question. There are no special igniters to use with Natrual Gas or LP. The same igniter can be used with each type of gas! Good luck with your repair!

1 person found this helpful.

Was this helpful?
Thank you for voting!
Ivan
June 30, 2021
Dryer does not get hot enough.
For model number ngd7200TW
PartSelect logo
Hello Ivan, Thank you for the question. We suggest testing the Thermistor. This part controls the temperature of the inside of the dryer drum. The thermistor will not read continuity but will read resistance when testing with a multimeter. We hope this helps, good luck with this repair!

Was this helpful?
Thank you for voting!
Related Parts:
  • 1
You May Also Need ?
Model Cross Reference
This part works with the following models:
PartSelect Number: PS11741122
Manufacturer Part Number: WP33002789
Brand
Model Number
Description
Samsung
DV203AGSXAA
Dryer - Samsung Dryer Model DV203AGSXAA Parts
Samsung
DV203AGWXAA
Dryer - Samsung Dryer Model DV203AGWXAA Parts
Samsung
DV206AGSXAA
Dryer - Samsung Dryer Model DV206AGSXAA Parts
Samsung
DV218AGBXAA
Dryer - Samsung Dryer Model DV218AGBXAA Parts
Samsung
DV218AGWXAA
Dryer - Samsung Dryer Model DV218AGWXAA Parts
Samsung
DV219AGBXAA
Dryer - Samsung Dryer Model DV219AGBXAA Parts
Samsung
DV219AGWXAA
Dryer - Samsung Dryer Model DV219AGWXAA Parts
Samsung
DV2C6BGWXAA
Dryer - Samsung Dryer Model DV2C6BGWXAA Parts
Amana
DV306LGW
Dryer
Amana
DV316BGC
Dryer
Amana
DV316BGW
Dryer
Samsung
DV316LGWXAA
Dryer - Samsung Dryer Model DV316LGWXAA Parts
Samsung
DV317AGGXAA
Dryer - Samsung Dryer Model DV317AGGXAA Parts
Samsung
DV317AGWXAA
Dryer - Samsung Dryer Model DV317AGWXAA Parts
Samsung
DV328AGGXAA
Dryer - Samsung Dryer Model DV328AGGXAA Parts
Samsung
DV328AGRXAA
Dryer - Samsung Dryer Model DV328AGRXAA Parts
Samsung
DV328AGWXAA
Dryer - Samsung Dryer Model DV328AGWXAA Parts
Samsung
DV331AGRXAA
Dryer - Samsung Dryer Model DV331AGRXAA Parts
Samsung
DV337AGGXAA
Dryer - Samsung Dryer Model DV337AGGXAA Parts
Samsung
DV337AGLXAA
Dryer - Samsung Dryer Model DV337AGLXAA Parts
Samsung
DV337AGRXAA
Dryer - Samsung Dryer Model DV337AGRXAA Parts
Samsung
DV337AGWXAA
Dryer - Samsung Dryer Model DV337AGWXAA Parts
Samsung
DV338AGBXAA
Dryer - Samsung Dryer Model DV338AGBXAA Parts
Samsung
DV338AGWXAA
Dryer - Samsung Dryer Model DV338AGWXAA Parts
Amana
DV3C6BGW
Dryer
Samsung
DV419AGUXAA
Dryer - Samsung Dryer Model DV419AGUXAA Parts
Samsung
DV419AGWXAA
Dryer - Samsung Dryer Model DV419AGWXAA Parts
Samsung
DV448AGPXAA
Dryer - Samsung Dryer Model DV448AGPXAA Parts
Samsung
DV448AGWXAA
Dryer - Samsung Dryer Model DV448AGWXAA Parts
Samsung
DV511AGWXAA
Dryer - Samsung Dryer Model DV511AGWXAA Parts
Customer Service Representative

Get in touch, we're here to help!

Monday to Saturday
8am - 9pm EST

Contact Customer Service