Models > DV203AGSXAA

DV203AGSXAA Samsung Dryer - Overview

Sections of the DV203AGSXAA

[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
Dryer Radiant Flame Sensor – Part Number: WP338906
Dryer Radiant Flame Sensor
★★★★★
★★★★★
(12)
PartSelect #: PS11741429
Manufacturer #: WP338906
If your gas dryer is not heating up or igniting, then replacing the flame sensor, located in the burner assembly, could solve it. This part senses heat from the igniter to monitor if it is hot enough ...
$49.32
  In Stock
Light Bulb - 10W – Part Number: WP22002263
Light Bulb - 10W
★★★★★
★★★★★
(16)
PartSelect #: PS11739347
Manufacturer #: WP22002263
This ten watt appliance light bulb is two inches tall. It is used with both washers and dryers.
$12.11
  In Stock
Screw – Part Number: W11233072
Screw
★★★★★
★★★★★
(6)
PartSelect #: PS12349731
Manufacturer #: W11233072
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch...
$19.99
  In Stock
Drive Belt – Part Number: 6602-001655
Drive Belt
★★★★★
★★★★★
(17)
PartSelect #: PS4133825
Manufacturer #: 6602-001655
The drum belt attaches to the motor pulley and causes the drum to spin as the motor is rotating. The drum belt is made of black rubber. This is an easy repair and should only take a few minutes. This ...
$43.33
  In Stock
Thermistor – Part Number: DC32-00007A
Thermistor
★★★★★
★★★★★
(16)
PartSelect #: PS4204984
Manufacturer #: DC32-00007A
This is a thermistor, also known as a dryer thermistor. The thermistor is attached to the blower housing, it will help regulate and oversee the temperature within the dryer. The most common symptom of...
$27.18
  In Stock
Idler Pulley Assembly – Part Number: DC93-00634A
Idler Pulley Assembly
★★★★★
★★★★★
(22)
PartSelect #: PS11771601
Manufacturer #: DC93-00634A
$59.11
  In Stock
Thermistor – Part Number: WP35001191
Thermistor
★★★★★
★★★★★
(6)
PartSelect #: PS11741828
Manufacturer #: WP35001191
This part controls the temperature of the inside of the dryer drum and prevents the dryer from overheating.
$55.54
  In Stock
Thermal Fuse – Part Number: DC47-00016A
Thermal Fuse
★★★★★
★★★★★
(5)
PartSelect #: PS4205213
Manufacturer #: DC47-00016A
This thermostat is a genuine OEM part and is manufacturer-approved for electric dryers. The thermostat is responsible for monitoring and maintaining the temperature inside the dryer during the drying ...
$22.69
  In Stock
Drum Support Roller & Axle – Part Number: DC97-16782A
Drum Support Roller & Axle
★★★★★
★★★★★
(7)
PartSelect #: PS4221885
Manufacturer #: DC97-16782A
The drum support roller and axle, which includes the roller shaft and mounting clips, is used in dryers. This part holds the drum as it rotates on the support wheels. When the roller begins to wear ou...
$40.68
  In Stock
Thermostat – Part Number: WP35001087
Thermostat
PartSelect #: PS11741821
Manufacturer #: WP35001087
This thermostat helps to regulate the dryer's internal temperature.
$43.28
  In Stock
IGNITER ASSEMBLY – Part Number: WP33002789
IGNITER ASSEMBLY
★★★★★
★★★★★
(1)
PartSelect #: PS11741122
Manufacturer #: WP33002789
This part ignites the gas within the dryer.
$55.89
  In Stock
Clamp-Motor – Part Number: WP660658
Clamp-Motor
★★★★★
★★★★★
(2)
PartSelect #: PS11743369
Manufacturer #: WP660658
This clamp is used to secure the drive motor.
$10.76
  In Stock

Questions And Answers for DV203AGSXAA

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Common Symptoms of the DV203AGSXAA

[Viewing 7 of 7]
No heat or not enough heat
Fixed by
these parts
Show All
Will Not Start
Fixed by
these parts
Show All
Noisy
Fixed by
these parts
Show All
Will not tumble
Fixed by
these parts
Show All
Shuts off too soon
Fixed by
these parts
Show All
Takes too long to dry
Fixed by
these parts
Show All
Lid or door won’t close
Fixed by
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Dryer did not turn when power was on.
Callled the service company to diagnose the problem. Watched him take machine apart. He found the problem. Told me the parts that I needed. Didnt know what they were. Went to partselect.com looked my model up and found parts and ordered. Followed same steps as repair guy: Two screws in back of machine then slide top off. Six screws in front to remove front door ( 4 screws on top 2 on bottom) Changed the thermostat and thermistor. Saved 320 dollars :)
Parts Used:
Thermistor Thermostat
  • JAMIE from VALLEY STREAM, NY
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
50 of 58 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Gas Flame Would Drop Out
First it was a process of alimination to find out why it was dropping out. After the problem was found it was just a matter of replacing the holding coil on the gas valve. Thank you fred kenney sr
Parts Used:
Dryer Radiant Flame Sensor
  • FRED from BRIELLE, NJ
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Screw drivers
47 of 64 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dryer would not heat up.
I unplugged the dryer,removed the two small screws on the front of the dryer and pulled the bottom forward. The two wires connected to the door do not have to be removed. With an electrical tester using the Ohm setting I tested the Radiant sensor and the Gas Valve coils. The two terminal coil was DOA. The dryer can be operated with the front open as long as the door wires are connected. Symptons: The igniter would heat up and not release gas. My repair was successfull due to this awesome website and the super fast shipping service. AAAA++++
Parts Used:
Dryer Radiant Flame Sensor
  • Roger from Bonners Ferry, ID
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Nutdriver, Screw drivers
26 of 29 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!