Ask our experts a question about this part and we'll get back to you as soon as possible!
3 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Pamela
September 24, 2017
Do you have a video that shows how to install the part.I can not find it on the website.Thank you
For model number Maytag PAV3300AWW
Hi Pamela, Thank you for the question, we do not offer a video as of yet for this part. The previous customer that stated they watched the video was referring to the one offered for the snubber ring they also ordered. To install the leg and foot you just need to tip the appliance back and line the leg up with the hole and set the appliance down. Hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Richard
February 5, 2018
Are there any instructions or videos for replacing the rear leg on model mav8600aww washer. This is the long foot attached to the balance bar (the part select # is wp22004469 replaces: 22004469, 35-2050) ? Thank you. Richard (silver spring md)
For model number MAV8600AWW
HI Richard , Thank you for the question. Very sorry but we do not have a video as of yet for this Rear Leveling Leg and Foot with Pad.To install the leg and foot you just need to tip the appliance back and line the leg up with the hole and set the appliance down. Hope this helps!
Was this helpful?
Thank you for voting!
Tim
February 6, 2018
I am replacing the snubber ring and motor drive belt, noticed the rear self leveling legs rubber pads had worn through. I am going to replace the legs, it appears i will have to detach housing from the base to reach the pins for the legs, is this correct? And is there a spring for the leveling bar, the diagram does not show one. Thank you. Tim
For model number PAV2300AWW
Hello Tim, thank you for your question. There is no spring for the rear leveling bar. To install the leg and foot you just need to tip the appliance back and line the leg up with the hole and set the appliance down. Hope this helps!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
Something went wrong. Please try again later.
Your Question Has Been Submitted!
Our experts will send you an email as soon as your question has been answered.
