Ask our experts a question about this part and we'll get back to you as soon as possible!
3 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Bryan
July 29, 2021
Fridge part is too cold, what is the procedure I should follow to find the wrong parts?
For model number GLHS67EHW6
Hello Bryan, Thank you for the question. We suggest checking the Damper Assembly to make sure it is opening and closing properly and not stuck in a open position allow to much cold air through. We also suggest testing the Defrost Thermostat. The best way to do this is to remove the thermostat from the refrigerator so you can control the temperature of the sensor. You can let the sensor warm up to room temperature. With the sensor warmed up to room temperature the sensor should read approximately 6.2K Ohms at 68°F. With the thermistor submerged is a glass full of ice water, the sensor should be very close to 32°F which should read approximately 16.3K Ohms. If the values that you are getting are far off from these readings, then the sensor is bad and should be replaced. We hope this helps!
Is this part located in the freezer behind ice maker and is this a cause of code sy -ef
For model number LGHS2665KF0
Hello Jon, thank you for your inquiry. PS1146084 is not compatible with your model LGHS2665KF0. If you are experiencing an SY EF error code, we recommend replacing part PS1526073. This is the Refrigerator Evaporator Fan Motor. I hope this information helps!
Was this helpful?
Thank you for voting!
Bryan
July 28, 2021
Storage side is too cold, thermistor was replaced 4~5 years ago, should i replace it again ?
For model number fridgidair GLHS67EHW6
Hi Bryan,
Thank you for your question. If your freezer section is too cold, there are some parts that you will need to check to see which one is causing the issue. You will need to check the air damper assembly, the thermistors, the defrost thermostat and the evaporator fan motor. We hope this helps! Good luck with the repair!