All Installation Instructions for Whirlpool Microwave YGMH6185XVB0

Replace filters

For grease filter, just slipped it in outside area. For charcoal filter, unscrewed the top of microwave and replaced existing filter, then screwed back the top.

Parts Used:

Grease Filter

Charcoal Filter

David F from BONITA SPRINGS, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Needed a clean filter

Stood on a step stool (microwave over stove), took off the one panel,removed old filter and put in new one

Parts Used:

Charcoal Filter

Ethel from New Berlin, WI
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Broke glass tray

Arrived in 24hours!!! Great.

Parts Used:

Glass Cooking Tray

Katherine from Cleveland, TN
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

Reminder signal and message to change filter on microwave digital display.

Removed 2 screws on the top of the microwave and removed top/front piece of microwave. Slid out old filter (which didn't look dirty at all) and replaced it with the new one. Replaced top/front piece and 2 screws. It took less than 5 minutes.

Parts Used:

Charcoal Filter

Susan from North Olmsted, OH
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Noisy turntable motor

Unplug microwave. Remove turntable and support from inside. Remove outside bottom cover (10 screws). Remove 2 torx screws holding motor in place. Remove 2 wires from motor, noting colors. Wires are held with spade connectors that has a small tab that needs to be depressed. Remove washer from motor and place on new motor. Entire procedure very easy.

Parts Used: