WRS23MW3AQS Crosley Refrigerator - Instructions

Pryed the old loose catch is on the bottom used a common screw driver.pulled the two wires off reversed the procedeure to put the new switch in.took about 5 minutes.

Installed new support. I placed the new one in the hole provided and taped in the locking peg with a small hammer. The total installation took about three minutes thanks to the excellent video provided on the web site. Thanks

The water flow on or refrigerator was just trickling out. After trying to make sure there was no kink in hose, I called for replacement. Water flows great now... actually better than when new.

replace the control panel and harness

removed the drip tray. removed three srcews that secure the frame around the ice and water dispenser. Disconnect the wire harness. Removed three more screws and disconnected another wire harness. Pulled the water tube from the assembly.Removed two screws remove old ice actuator and then installed the new ice actuator with two screws. reconnected a wire harness and then three screws to assemble the assembly to the frigerator. Then reinserted the water tube. replaced the frame with three screws and enjoyed and a cool drink with ice again.Easiest repair that I have ever done.

I was worried that the support was a permanent fixture in the refrigerator wall. But I pried it out and replaced it with the new part. Holes were exactly the same size so the new part easily replaced the old one.

Purchase was easy. Delivery was quick. Install videos was accurate. Made it eady to as DI project. Safe place for purchase and support. Saved on cost of professional visit.

Since the evaporator was all iced up, I decided to replace the least costliest item (defrost thermostat kit); did not resolve the problem. Once I replaced the freezer temperature control thermostat, the freezer temperature stabilized right at 0 degrees fahrenheit with dial on factory setting. Compressor no longer running constantly.

removed backing to refrig unscrewed 2 screws from bracket pulled unit out unhooked hoses and elec plug's / putting in new just reversed the instalation

Remove crisper and shelf. Use a small punch and hammer to gently push the tightening pin through to the wall of refrigerator, keep in mind you'll need to remove this piece with small needle nose pliers before installing new part. Set new part in place and lightly tap the pin in until flush. Install crisper and enjoy the rest of your day.

Remove cover, puch old pin into hole. Remove old support. Set new support in & drive pin in flush. Replace cover.

My part had threaded fittings. The part that I received had snap fittings. Once I realized that that snap fittings worked with the bare tubing and not any special tip endings, I simply cut off the ends of my tubing that mated with the threaded fittings. I then had bare tubing that snapped into the snap fittings. Two minutes later, the part was in place and the job was done. Problem solved.

remove and replace socket. adjust light switch so that it turns light off when door closes.

Undone the water line that comes up the back of the refrigerator and pulled the water tube out the back of the refrigerator and reinstalled the new one and reinstalled the water line. Done

Removed broken cover frame and drawer.: saved unbroken glass .With putty knife removed two front broken support clips.Inserted new support clips installed new ,cover frame installed drawer replaced glass cover and turned refer over to wife.