WRS23MF5AS3 Westinghouse Refrigerator - Instructions

Took out the old one and pushed in the new one. Easy, peasy.

I followed the instructions provided in the Part Select video and replaced the bearing. The most time consuming part of the job was emptying (and then cleaning) the items stored in the bins inside the door shelves. Removing the broken bearing was a little more difficult because mine was old and broken and I didn't have an empty table to lay the door on like the video studio did--the floor worked in place of the table.

I removed the food on the door and placed it in the refrigerator. I placed a plastic sheet over the opening of the refrigerator to keep the cold air in. Then I removed the bracket for the upper hinge, remover the door and placed it onto a table. Then I removed the plastic bearing from the bottom of door. I then replaced it with the new bearing. Then I removed the lower bearing and its bracket from the refrigerator. At this point I had to modify the new lower bracket by removing the alignment tab with a dremel because there wasn’t any hole in the housing for it. Then I attached the new bracket and bearing. Replaced the door and upper hinge and the job was complete. It took only about a half an hour to finish.

Followed the instructions from another person in the Part Select water valve section and from the video on the same page. Excellent instructions and very easy installation. Water dispenser and ice maker began performing properly as soon as the refrigerator was plugged back in to the power.

Slid the new one in easy !

watched a youtube video in removing and replacing the unit which made it very easy to follow through. we actually went without the ice maker for 6 months before this not realizing how easy and affordable it was to replace.

We decided to get a new fridge, after the " sticker shock " of new refrigerators we decided to repair the one we have. Two screws and one plug and the ice maker was replaced, took out the broken crisper shelf, put in the new one and that was done, instructions were great. I actually had to watch a " how to " video, ( provided by your web site ) to change the shelf support, very easy. thanks, Gary Hoyle

I watched the video and it seemed pretty easy. I ordered the new ice maker. It arrived in 5 days and I chanted it in less the 30 minutes. A little tricky seeing where you have to loosen the screws but not hard. and in 2 hours I had ice again.

Snap out and snap in.

after watching the video I followed to the tee used the screw driver tapped out the old peg and removed the stem in minutes I was tapping in the new parts

Push the button on the right side of the ice maker filter compartment which releases the old filter. Just pull old filter out and slide the new filter all the way in. Be sure and mark on the new filter the date that will be time to change the filter again. I ordered the filter on one day and received the filter in the mail the next day and I had not paid extra for overnight shipping.

The repair was easy. After looking at the diagram and locating the part need i just ordered it. But I wish I had taken the door off before ordering as I really need a second part. So resulting in extra shipping cost. Parts that were needed were 240328201 and 240457702. Tks Jim

I pushed the button to eject the old cartridge - it came out - I pushed the new one in until it locked in place - I reset the filter light on the front. This took less than 1 minute.

If this happens to you the first thing I would do is shut off the freezer and, using a hair dryer, melt the ice in the ice maker and heat up the water inlet to make sure it is not froze up. Turn the freezer back on and wait to see if that cures the problem. If not, order the new water inlet valve and follow the simple instructions in the video provided on the PartSelect website. I have never have a more pleasant experience with any parts/repair service than I did with PartSelect. After ordering that part it came within the time they stated and their help with the install was great. Also helpful were the other customers talking about their problems and solutions.Thanks to PartSelect I now have Ice and a happy wife. Happy wife--happy life.

These bins just snapped into place. very easy.