WEF303PHDA Westinghouse Range - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Oven bake element died
repaired in 5 minutes with my nut driver. So, so, so easy to make this repair. And never even attempted to call an electrician. Since long before I became an official widow, I say...who needs a man...
Parts Used:
-
Dawn from Warren, MI
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver
Was this instruction helpful to you?
Thank you for voting!
Bake element stopped working after 17 years
Unscrewed the two screws which held element in place...pulled straight out...gently pulled connector terminals off....replaced with new element connecting element terminals ...sliding element back into place (make sure terminal connection is straight (ie NOT BENT) when pushing element back into original position)and screwing screws back in...DONE!!! EASY PEASY!!!
Parts Used:
-
Michael from Lockport, NY
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
bake element burnt into
removed the screw at the mount on each side of element .pulled old element straight out untill wire connector was out at the back of oven ..unplugged wire connector from each end of old element ..plugged wire connectors back into new element .pushed element plugs back into back of oven and installed each screw that holds element into place.. real simple
Parts Used:
-
JEFFREY from HIGHPOINT, NC
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver
Was this instruction helpful to you?
Thank you for voting!
the bakely element was burned into in two different places
aftering watching your repair video the repair went very well we took the oven door off to make access easier. the worst part of the repair was getting the door back on.
Parts Used:
-
jannetta from clarkton, MO
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver
Was this instruction helpful to you?
Thank you for voting!
Oven would not heat to temperature
Undo the two nut screws pulled out the element and replaced it with the new one.
Parts Used:
-
Robert from Lorena, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver, Pliers
Was this instruction helpful to you?
Thank you for voting!
Element burned out; needed replacement
Followed instructions on YouTube and Frgidaire website. It looked easy; was easier than it looked -)
Parts Used:
-
Michael from Spicer, MN
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Socket set
Was this instruction helpful to you?
Thank you for voting!
Bottom oven element no longer working.
Removed old element by taking out two screws at bottom rear of oven. Pulled element and wires forward from two holes and unclipped from wires. Clipped new element to wires and pushed the wires back into the holes. Then replaced the two screws. Needed flashlight so that 60+ eyes could see the screws and holes in the oven. A quick and inexpensive repair. Element was delivered very quickly.
Parts Used:
-
Frances from Garner, NC
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers, Socket set
Was this instruction helpful to you?
Thank you for voting!